Subaru Legacy/Outback

1999-2003 of release

Repair and car operation


Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
+ The engine
- Systems of cooling, heating
   Specifications
   + System of cooling of the engine
   - Heating/ventilation/air conditioning systems
      Removal and installation дефлекторов and air lines
      Removal and installation of resistive assemblage drive the electromotor of the fan of a heater
      Removal, check and installation drive the electromotor of the fan of a heater
      Removal and installation of the control panel by functioning of systems of heating/ventilation/air conditioning
      Removal and installation of assemblage of a heater
      Removal and installation of the heat exchanger of a heater
      Check of serviceability of functioning and service of systems of heating and air conditioning
      Compressor K/V - a design and a functioning principle
      Condenser K/V - a design and a functioning principle
      Receiver-dehumidifier К/В - a design and a functioning principle
      The gauge-switch of pressure К/В - a design and a functioning principle
      Evaporator K/V - a design and a functioning principle
      Broad valve K/V - a design and a functioning principle
      Condition check, removal and installation of the compressor of system K/V
      Removal and installation of the condenser of system K/V
      Removal and installation of a receiver-dehumidifier of system K/V
      Removal and installation of the inlet block of system K/V, evaporator replacement
      Replacement of connecting hoses of a refrigerator path
      Check of serviceability of functioning of the gauge-switch of pressure
      Removal and installation of information gauges of system of an automatic central air (climate control)
+ The power supply system and release
+ Engine electric equipment
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Condenser K/V - a design and a functioning principle

Arriving from a compressor exit разогретый to a heat and strongly compressed gaseous coolant is cooled in the evaporator, and then in the condenser is translated in a liquid state.

The condenser represents the heat exchanger consisting of the complete set of tubes, surrounded with cooling plates.

Selected from the heat exchanger of a coolant passing on tubes heat is deduced радиаторными by plates in atmosphere. Efficiency of functioning of the condenser is provided at the expense of a stream of air banished between plates by fans of system of cooling.


On the main page