Subaru Legacy/Outback

1999-2003 of release

Repair and car operation



Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
+ The engine
- Systems of cooling, heating
   Specifications
   + System of cooling of the engine
   - Heating/ventilation/air conditioning systems
      Removal and installation дефлекторов and air lines
      Removal and installation of resistive assemblage drive the electromotor of the fan of a heater
      Removal, check and installation drive the electromotor of the fan of a heater
      Removal and installation of the control panel by functioning of systems of heating/ventilation/air conditioning
      Removal and installation of assemblage of a heater
      Removal and installation of the heat exchanger of a heater
      Check of serviceability of functioning and service of systems of heating and air conditioning
      Compressor K/V - a design and a functioning principle
      Condenser K/V - a design and a functioning principle
      Receiver-dehumidifier К/В - a design and a functioning principle
      The gauge-switch of pressure К/В - a design and a functioning principle
      Evaporator K/V - a design and a functioning principle
      Broad valve K/V - a design and a functioning principle
      Condition check, removal and installation of the compressor of system K/V
      Removal and installation of the condenser of system K/V
      Removal and installation of a receiver-dehumidifier of system K/V
      Removal and installation of the inlet block of system K/V, evaporator replacement
      Replacement of connecting hoses of a refrigerator path
      Check of serviceability of functioning of the gauge-switch of pressure
      Removal and installation of information gauges of system of an automatic central air (climate control)
+ The power supply system and release
+ Engine electric equipment
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Replacement of connecting hoses of a refrigerator path

The scheme of an arrangement of connecting hoses in a refrigerator path of a central air

And — the Hose низконапорной lines
In — the Hose высоконапорной lines

With — Fixing bolts
D — Fixing bolts


 PERFORMANCE ORDER

 The detachment/connection of hoses should be made, without putting to them twisting effort! Watch, that the connected hoses have not been overwound. It is necessary to cork the open ends of refrigerator lines at once approaching заглушками!

1. Make a discharge of a central air in the conditions of a specialised workshop.
2. Disconnect a negative wire from the battery.
3. Remove an air inlet (see Has undressed Service of components of an inlet air path).
4. Turn out fixing bolts (), disconnect низконапорный a hose from the evaporator and the compressor and remove it from the car.
5. Turn out bolts (D), disconnect высоконапорный a hose from the compressor and the condenser and remove it from the car.
6. Attentively study a condition of the removed hoses. In case of revealing of cracks, cuts and other damages replace defective components.
7. Installation is made upside-down, - add in the compressor of refrigerator oil of 1 ml.

 The central air recharge should be made in the conditions of a car-care centre workshop.

On the main page