|
1. Disconnect a negative wire from the battery.
2. Having pulled outside, liberate LLC.
3. Remove an air cleaner (see the Head of the Power supply system and release).
|
|
4. Release collars and disconnect heating hoses from heat exchanger branch pipes on a back partition of an impellent compartment. |
5. Remove the inlet block of system K/V (see Has undressed Removal and installation of the inlet block of system K/V, evaporator replacement).
|
|
6. By means of a key of type TORX turn out screws of fastening of the block of management SRS. |
|
|
7. Disunite a contact socket of the main plait of electroconducting SRS near to a basic beam of a steering column. |
8. Release fixing bolts and nuts of fastening of a basic beam.
9. Disunite a servo-driver socket.
|
|
10. Release fixing bolts and nuts and remove heater assemblage. |
11. Installation is made upside-down. |