Citroen Xantia

Since 1993 of release

Repair and car operation

Removal and steering wheel installation

Models without a safety pillow

Removal

PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Accurately having hooked, remove the central overlay of a steering wheel.
3. At a corresponding complete set disconnect electroconducting from a payment of remote control by functioning of the radio tape recorder located in a groove in the top part of a steering wheel.
4. Give a fixing nut and remove a steering wheel from a column shaft (at a corresponding complete set track liberation of electroconducting from the central part of a wheel).

Installation

Installation is made upside-down. At a corresponding complete set track correctness of a lining of electroconducting. A fixing nut tighten with demanded effort.

The models equipped with a pillow of safety

The electronic block of management (ECU) safety pillows is built in in steering wheel assemblage, - try not to damage the block in the course of dismantle of the last.

Removal

PERFORMANCE ORDER

1. Remove the module of a pillow of safety (address to the Head the Onboard electric equipment).
2. At a corresponding complete set disconnect electroconducting from a payment of remote control by functioning of the radio tape recorder established in a groove in the top part of a steering wheel.
3. Liberate a contact socket of electroconducting of a pillow of safety from a clamp on a steering wheel and disunite it.
4. Give a nut of fastening of a steering wheel. In the course of removal of a wheel from a shaft of a steering column track for продеванием electroconductings through it ступичную a part.
5. Transfer the removed steering wheel to a storage place. Try not to damage ECU a safety pillow.

Installation

Installation is made upside-down. Pay attention to following moments:
   a) Track correctness of a lining of electroconducting;
   b) Track observance of demanded effort of a tightening of a nut of fastening of a steering wheel;
   c) do not forget to establish into place the module of a pillow of safety (address to the Head the Onboard electric equipment).

On the main page