Removal and installation of the proof-reader of height of a road gleam of a forward suspension bracket
Removal
|
|
At a corresponding complete set be required new sealing муфты штуцерных sockets of hydraulic tubes. |
|
|
|
1. Dump pressure in hydraulic system (the Uniform hydraulic system see the Head).
2. Поддомкратьте the car also establish it on props
3. Mark adjusting position of hydraulic tubes, then disconnect them from assemblage of the proof-reader of a road gleam. Get under assemblage of the proof-reader suitable drain capacity and disconnect hydraulic tubes. At once закупорьте the open ends of tubes and unions of their connection for the purpose of minimisation of losses of a liquid and in order to avoid hit in dirt system. |
|
4. Turn out bolts of fastening of the proof-reader and liberate приводные rods from the executive lever of assemblage, remembering adjusting positions of components. Take assemblage of the proof-reader from under the car.
1 — two hydraulic tubes
2 — fastening bolts |
|
|
Installation
Regenerative repair of the proof-reader of height of a road gleam is not obviously possible. In case of a device exit out of operation make its replacement in gathering.
Installation is made upside-down. Pay attention to following moments:
a) Track correctness of connection and reliability of fastening of hydraulic tubes, at a corresponding complete set do not forget to replace sealing муфты штуцерных sockets;
b) do not forget to grease spherical hinges drivers rods before their connection to the executive lever of the proof-reader;
c) After car lowering on the earth tighten спускной the gate of a regulator of pressure and translate a control lever a suspension bracket in position "Maximum";
d) Check up level of a hydraulic liquid, in case of need make corresponding updating (address to the Head Routine maintenance);
e) In summary check up installation of a road gleam (Check of installation and adjustment of a road gleam see).
|