Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
- Running gear and steering
   Removal and installation ступичной assemblages of a forward suspension bracket
   Replacement of bearings of forward naves
   Removal, major repairs and installation of the bottom lever of a forward suspension bracket
   Removal and installation of the bottom spherical support of a forward suspension bracket
   Removal and installation of components of the stabilizer of cross-section stability of a forward suspension bracket
   Removal and installation of assemblages of racks / hydraulic blocks of a forward suspension bracket
   Removal and installation of the proof-reader of height of a road gleam of a forward suspension bracket
   Removal and installation of a stretcher of a forward suspension bracket
   Removal and installation of naves of back wheels
   Replacement back ступичных bearings
   Removal and installation of longitudinal levers of a back suspension bracket
   Removal and installation of assemblage of the back bridge
   Removal and installation of hydraulic blocks of a back suspension bracket
   Removal and installation of the proof-reader of a road gleam of a back suspension bracket
   Check of installation and adjustment of a road gleam
   Removal and steering wheel installation
   Removal, check of a condition of components and installation of a steering column
   Removal and installation of assemblage of the switch of ignition/lock of a steering column
   The steering mechanism - the general data, removal, major repairs and installation
   System of hydrostrengthening of a wheel - the general data
   Removal and installation of tips of steering draughts
   Corners of installation of wheels - the general information, check and adjustment of convergence of forward wheels
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes

Removal and installation of assemblage of the switch of ignition/lock of a steering column

Removal

 PERFORMANCE ORDER

1. Execute the procedures described in section Removal, check of a condition of components and installation of a steering column (subsection Removal ", subitem 1-7).
2. Under a steering column find two contact sockets of electroconducting of the switch of ignition and disunite them. Liberate wires from intermediate clamps.

3. Turn out the fixing screw in a back part замковой assemblages.

4. Insert into the lock the ignition key and turn it in average position between labels "And" and “S”.

5. A small screw-driver with a flat sting wring out a lock uvula of a fixing clamp.

6. For a key extend замковую assemblage from the casing.

Installation

Installation is made upside-down. Pay attention to following moments:
   a) Track reliability защелкивания a lock uvula of a fixing clamp;
   b) Before to establish casings of a steering column make sure of serviceability of functioning of its lock;
   c) the Description of procedure of installation of a steering wheel is resulted in section Removal and steering wheel installation.


On the main page