Citroen Xantia

Since 1993 of release

Repair and car operation


Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
- Running gear and steering
   Removal and installation ступичной assemblages of a forward suspension bracket
   Replacement of bearings of forward naves
   Removal, major repairs and installation of the bottom lever of a forward suspension bracket
   Removal and installation of the bottom spherical support of a forward suspension bracket
   Removal and installation of components of the stabilizer of cross-section stability of a forward suspension bracket
   Removal and installation of assemblages of racks / hydraulic blocks of a forward suspension bracket
   Removal and installation of the proof-reader of height of a road gleam of a forward suspension bracket
   Removal and installation of a stretcher of a forward suspension bracket
   Removal and installation of naves of back wheels
   Replacement back ступичных bearings
   Removal and installation of longitudinal levers of a back suspension bracket
   Removal and installation of assemblage of the back bridge
   Removal and installation of hydraulic blocks of a back suspension bracket
   Removal and installation of the proof-reader of a road gleam of a back suspension bracket
   Check of installation and adjustment of a road gleam
   Removal and steering wheel installation
   Removal, check of a condition of components and installation of a steering column
   Removal and installation of assemblage of the switch of ignition/lock of a steering column
   The steering mechanism - the general data, removal, major repairs and installation
   System of hydrostrengthening of a wheel - the general data
   Removal and installation of tips of steering draughts
   Corners of installation of wheels - the general information, check and adjustment of convergence of forward wheels
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes

Removal and installation of the bottom spherical support of a forward suspension bracket

For a reversing and a tightening of a spherical support the special tool of type Citroёn № 7103-7 and a shock key of type “Facom Dynapact”) is required. At absence of near at hand demanded tools it is necessary to charge performance of the given work to experts of car-care centre. At all do not undertake attempts of removal of a spherical support by means of make-shifts! The new nut of a spherical finger Is required also.

Removal

 PERFORMANCE ORDER

1. Dump pressure in hydraulic system (the Uniform hydraulic system see the Head).
2. Prop up противооткатными boots back wheels, then поддомкратьте redock of the car and establish it on props. Remove a corresponding forward wheel.
3. Loosen the and partially turn away a nut of a finger of the bottom spherical support (turn away a nut till the end of a carving fingers for the purpose of protection of coils by last at hinge liberation). Liberate шаровый a finger from ступичной assemblages by means of a divider of spherical support, then definitively remove a nut.

4. By means of approaching выколотки bring down the dustproof screen of a spherical support.

5. Enter the special tool 7103-7 into gearing with cuts on assemblage of a spherical support and fix it by a counternut tightening on a carving part of a spherical finger. Connect to the tool a shock key and turn out assemblage of a spherical support.

Installation

Installation is made upside-down. Pay attention to following moments:
   a) Before definitively to tighten with demanded effort a support by means of the special tool, screw it as it is possible more strongly by hand;
   b) Try not to damage at installation of components a rubber protective cover of a support;
   c) do not forget зачеканить the dustproof screen of a spherical support in cuts in the bottom part ступичной assemblage;
   d) After car lowering on the earth tighten спускной the gate of a regulator of pressure and translate a control lever a suspension bracket in position "Maximum".


On the main page