Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
- Engine repair
   - The repair procedures which are not demanding extraction of the engine from the car - petrol engines
      Check компрессионного pressure in cylinders
      Fixing cranked / distributive shaft for the purpose of prevention casual in the course of performance of procedures of service of the car
      Removal and installation of a cover of a head of cylinders
      Removal and installation of a pulley of a cranked shaft
      Removal and installation of covers газораспределительного a belt
      Belt of drive ГРМ - the general information, removal and installation
      Removal, check of a condition and installation натяжителя and cogwheels газораспределительного a belt
      Epiploon replacement (ов) a camshaft
      Removal, check of a condition and installation of a camshaft and pushers of valves
      Check and adjustment клапанных backlashes
      Removal and installation of a head of cylinders
      Removal and pallet installation картера the engine
      Removal, check of a condition and installation of the oil pump
      Removal and installation маслоохладителя (models 2.0)
      Replacement of epiploons of a cranked shaft
      Removal, check of a condition and installation of a flywheel/privodnogo of a disk
      Check of a condition and replacement of support of a suspension bracket of the power unit
   + The repair procedures which are not demanding extraction of the engine from the car - diesel engines
   + Removal and engine major repairs
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes

Removal and installation маслоохладителя (models 2.0)

Removal

 PERFORMANCE ORDER

1. Cock a lay brake, then поддомкратьте redock of the car and establish it on props.
2. Empty cooling system (address to the Head Routine maintenance). Alternatively, press hoses охладительного a path directly over маслоохладителем and prepare for gathering of a spilt cooling liquid.
3. Get suitable drain capacity under the oil filter. By means of a special key turn on and remove the oil filter and merge from it oil in the prepared capacity. The damaged or deformed filter is subject to replacement. In view of insignificant cost and importance of the influence rendered on efficiency of return of the engine, composers of the present Management recommend to make replacement of the oil filter each time at its removal.
4. Release fixing collars and disconnect hoses from маслоохладителя.

5. Turn out a fastening bolt masloohladitelja / the oil filter to the block of cylinders and remove assemblage from the engine. Pay attention to an arrangement of a directing groove on a flange маслоохладителя, - it should sit down on a reciprocal ledge on the block. The sealing ring маслоохладителя is subject to replacement without fail.
And — the Fixing bolt
In — the Directing groove of assemblage masloohladitelja / the oil filter

Installation

 PERFORMANCE ORDER

1. Lay a new sealing ring in a flute from the back party маслоохладителя and press assemblage of the last to the regular place on the block of cylinders.
2. Track, that the directing groove has got on a reciprocal ledge on the block, then screw the fixing block and reliably tighten it.
3. Establish the oil filter, then lower the car on the earth and make updating of level of impellent oil (address to the Head Routine maintenance).
4. Add in cooling system necessary quantity of a cooling liquid (address to the Head Routine maintenance). Start the engine and check up маслоохладитель on presence of signs of leaks.



On the main page