Citroen Xantia

Since 1993 of release

Repair and car operation


Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
- Engine repair
   - The repair procedures which are not demanding extraction of the engine from the car - petrol engines
      Check компрессионного pressure in cylinders
      Fixing cranked / distributive shaft for the purpose of prevention casual in the course of performance of procedures of service of the car
      Removal and installation of a cover of a head of cylinders
      Removal and installation of a pulley of a cranked shaft
      Removal and installation of covers газораспределительного a belt
      Belt of drive ГРМ - the general information, removal and installation
      Removal, check of a condition and installation натяжителя and cogwheels газораспределительного a belt
      Epiploon replacement (ов) a camshaft
      Removal, check of a condition and installation of a camshaft and pushers of valves
      Check and adjustment клапанных backlashes
      Removal and installation of a head of cylinders
      Removal and pallet installation картера the engine
      Removal, check of a condition and installation of the oil pump
      Removal and installation маслоохладителя (models 2.0)
      Replacement of epiploons of a cranked shaft
      Removal, check of a condition and installation of a flywheel/privodnogo of a disk
      Check of a condition and replacement of support of a suspension bracket of the power unit
   + The repair procedures which are not demanding extraction of the engine from the car - diesel engines
   + Removal and engine major repairs
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes

Removal and installation of a cover of a head of cylinders

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

2. Release fixing collars and disconnect from the right first line of a cover of a head of cylinders ventilating hoses. The firm collars of braided type established on manufacturer should be cut off and at assemblage to replace more practical screw or worm.

3. Release a collar and disconnect from a forward wall of a cover of a head of cylinders connecting air cleaner with the case of a throttle an air inlet sleeve. Also disconnect an air inlet brought to a left edge of a cover.

4. Release two clamps, then turn out two located in front of the fixing screw and remove from a cover of a head of cylinders an air cleaner cover. Take filtering element and will put it aside together with an air cleaner cover.

5. In stages in regular intervals ослабьте ten fixing nuts also uncover heads of cylinders.

6. Remove also a sealing lining of a cover. Attentively study a lining condition, in case of revealing of mechanical defects or signs of ageing of a material make replacement.

Installation

 PERFORMANCE ORDER

1. Carefully smooth out and wipe interfaced surfaces of a head of cylinders and its cover, completely having removed from them oil traces.
2. Lay a rubber sealing lining in a flute on a head of cylinders, having tracked correctness of its landing on all length.

3. Grease with suitable hermetic of a cover of bearings from both ends of a camshaft in places of their joining with an interfaced surface of a cover of a head of cylinders.

4. Accurately, trying not to displace a lining, lay a cover of a head of cylinders on the engine.

5. Having made sure that the lining is not displaced, screw fixing nuts and in stages in regular intervals tighten them in a demanded order with the set effort.

6. Establish into place filtering element and an air cleaner cover. Strongly tighten fixing screws and latch clamps.
7. Connect to a cover of a head of cylinders ventilating hoses and air sleeves and reliably fix their fixing collars.
8. Connect a negative wire to the battery.



On the main page