Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
- Engine repair
   - The repair procedures which are not demanding extraction of the engine from the car - petrol engines
      Check компрессионного pressure in cylinders
      Fixing cranked / distributive shaft for the purpose of prevention casual in the course of performance of procedures of service of the car
      Removal and installation of a cover of a head of cylinders
      Removal and installation of a pulley of a cranked shaft
      Removal and installation of covers газораспределительного a belt
      Belt of drive ГРМ - the general information, removal and installation
      Removal, check of a condition and installation натяжителя and cogwheels газораспределительного a belt
      Epiploon replacement (ов) a camshaft
      Removal, check of a condition and installation of a camshaft and pushers of valves
      Check and adjustment клапанных backlashes
      Removal and installation of a head of cylinders
      Removal and pallet installation картера the engine
      Removal, check of a condition and installation of the oil pump
      Removal and installation маслоохладителя (models 2.0)
      Replacement of epiploons of a cranked shaft
      Removal, check of a condition and installation of a flywheel/privodnogo of a disk
      Check of a condition and replacement of support of a suspension bracket of the power unit
   + The repair procedures which are not demanding extraction of the engine from the car - diesel engines
   + Removal and engine major repairs
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes





Epiploon replacement (ов) a camshaft

If be going to make replacement of an epiploon of a camshaft without removal газораспределительного a belt, before check up last on presence of traces of pollution of oil (the greasy belt is subject to replacement without fail). Now take care of that that in the course of replacement of an epiploon oil did not get on a belt - wrap up last rags. If the belt is removed, before its installation carefully wipe all components of drive ГРМ and adjoining surfaces of the block/head, completely having cleared them of oil traces.


 PERFORMANCE ORDER

1. Remove a camshaft cogwheel (Removal, check of a condition and installation натяжителя and cogwheels газораспределительного a belt see).
2. Pierce or drill in a face surface of an epiploon pair of small apertures the friend opposite to the friend. Screw in apertures саморезы and, having grasped heads of the last nippers, take an epiploon from the nest.
3. Wipe a casing of an epiploon and remove teases and the agnails, capable to lead to failure of a new epiploon.
4. Grease sponges of a new epiploon with pure impellent oil and plant an epiploon in the nest against the stop in a special coat hanger. In quality оправки for epiploon landing it is possible to take advantage of a replaceable face head of the corresponding size or a piece of a pipe of suitable diameter. Оправка should rest only against firm external edge of an epiploon. Try not to admit damage of sponges.

The epiploon is established by sponges inside.

5. Establish into place a camshaft cogwheel (Removal, check of a condition and installation натяжителя and cogwheels газораспределительного a belt see).

On the main page