Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
- Engine repair
- The repair procedures which are not demanding extraction of the engine from the car - petrol engines
Check компрессионного pressure in cylinders
Fixing cranked / distributive shaft for the purpose of prevention casual in the course of performance of procedures of service of the car
Removal and installation of a cover of a head of cylinders
Removal and installation of a pulley of a cranked shaft
Removal and installation of covers газораспределительного a belt
Belt of drive ГРМ - the general information, removal and installation
Removal, check of a condition and installation натяжителя and cogwheels газораспределительного a belt
Epiploon replacement (ов) a camshaft
Removal, check of a condition and installation of a camshaft and pushers of valves
Check and adjustment клапанных backlashes
Removal and installation of a head of cylinders
Removal and pallet installation картера the engine
Removal, check of a condition and installation of the oil pump
Removal and installation маслоохладителя (models 2.0)
Replacement of epiploons of a cranked shaft
Removal, check of a condition and installation of a flywheel/privodnogo of a disk
Check of a condition and replacement of support of a suspension bracket of the power unit
+ The repair procedures which are not demanding extraction of the engine from the car - diesel engines
+ Removal and engine major repairs
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes
|
Removal and installation of covers газораспределительного a belt
Removal
Models 1.6 and 1.8 l
The top cover
|
|
|
1. Release clamps in the top part of a cover and liberate from them fuel hoses.
2. Turn out two fixing bolts in the basis of a cover and take last from an impellent compartment. |
|
The central cover
|
|
|
1. Turn out two fixing bolts, located directly under a support arm.
2. Shift a cover upwards, for removal from the directing pins located in the basis.
3. Take a cover from an impellent compartment. |
|
The bottom cover
|
|
|
1. Remove a pulley of a cranked shaft (Removal and installation of a pulley of a cranked shaft see).
2. Remove the central cover (see above).
3. Turn out two fixing bolts and remove the bottom cover from the engine. Pay attention that on some models it is necessary preliminary отболтить and to remove assemblage натяжителя auxiliary drive a belt. |
|
L models 2.0
The top cover
|
|
|
1. Release clamps in the top part of a cover and liberate from them fuel hoses. |
|
2. Turn out two fixing bolts. |
|
|
3. Take a cover from an impellent compartment, having pulled it upwards. |
|
|
The bottom cover
|
|
|
1. Remove a pulley of a cranked shaft (Removal and installation of a pulley of a cranked shaft see). |
|
2. Turn out three fixing bolts and remove the bottom cover газораспределительного a belt from the engine. |
|
|
3. Pay attention that on some models it is necessary preliminary отболтить and to remove assemblage натяжителя auxiliary drive a belt. |
|
|
Installation
Installation is made in an order, the return to a dismantle order. Track correctness of placing of covers and reliability of a tightening of fixture (Specifications see).
|
On the main page
|