Citroen Xantia

1. Remove a belt of a drive of auxiliary units (address to the Head Routine maintenance).

2. For fixing of a cranked shaft in time отдавания a bolt of fastening of a pulley include 4th transfer and ask the assistant to squeeze out a foot brake firmly. If the engine is removed from the car, block a gear wreath of a flywheel by means of the special adaptation.

Do not try to fix at all a shaft by продевания a core in a blocking aperture of a pulley (Fixing cranked/distributive shaft for the purpose of prevention casual in the course of performance of procedures of service of the car see)! If the core is already inserted, temporarily take it.

3. Turn out a fixing bolt, throw off a washer and remove a pulley from a pin of a cranked shaft. If the pin, or segment шпонка (depending on a complete set) is planted freely, take its/its and clean in a reliable place. If the pulley is planted on a shaft pin too densely, take advantage of a suitable stripper.

1. Make sure available on the place and reliability of landing segment shponki / a landing pin, then put on a pulley a pin of a cranked shaft.
2. Carefully smooth out a carving part of a fixing bolt, then grease with its fixing hermetic of type Loctite.
3. Screw a bolt (do not forget about a washer) and tighten it with demanded effort, keeping a cranked shaft from проворачивания in the same way to which resorted at отдавании.
4. Establish into place a belt of a drive of auxiliary units (address to the Head Routine maintenance).