Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
- 6. Fuel and exhaust systems
   - 6.1. Models with the carburettor
      6.1.1. A technical characteristics
      6.1.2. Use unleaded gasoline
      6.1.3. Removal and installation of the case of the air filter
      6.1.4. System of adjustment of temperature of air arriving in the engine
      6.1.5. Check, removal and installation of the fuel pump
      6.1.6. Removal and installation of the gauge of level of fuel
      6.1.7. Removal and installation of a fuel tank
      6.1.8. Removal, installation and adjustment of a cable of an accelerator
      6.1.9. Removal and installation of a pedal of an accelerator
      6.1.10. Removal, installation and adjustment of a cable of management air заслонкой
      + 6.1.11. Carburettors
      6.1.12. Check of the electromagnetic valve of a stopping delivery of fuel
      6.1.13. Removal and carburettor installation
      + 6.1.14. Carburettor repair
      6.1.15. Removal and installation of an inlet collector
      6.1.16. Removal and installation of a final collector
      6.1.17. Removal and installation of a heater of an inlet collector
      6.1.18. Removal and exhaust system installation
   + 6.2. Models with system of injection of fuel
   + 6.3. Models with engines 16D and 16DA
   + 6.4. Models with engines 17D and 17DR
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes





6.1.13. Removal and carburettor installation

Removal

PERFORMANCE ORDER
1. Remove a wire of weight from the accumulator.
2. Remove the air filter.
3. On hand-operated models air заслонки disconnect from the carburettor a cable of management air заслонкой. On models with automatic air заслонкой disconnect electric sockets and / or pipes of giving of a cooling liquid. For reduction of losses of a cooling liquid close the ends of pipes suitable stoppers.
4. Disconnect a hose of giving of fuel from steam or carburettor separator. At presence disconnect a hose of return of fuel from the carburettor. Close the ends of hoses suitable stoppers.
5. Disconnect an accelerator cable.
6. Disconnect from the carburettor a vacuum hose of the distributor of ignition.
7. Disconnect an electric socket from the electromagnetic valve blocking giving of fuel.
8. Disconnect the remained hoses or wires, then unscrew nuts and remove the carburettor from hairpins. Remove a carburettor lining.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal, taking into account following moments.
2. In the presence of defects use a new lining of the carburettor.
3. Adjust a cable of an accelerator and a cable of management air заслонкой.
4. If hoses of a cooling liquid acted in film, check up and, if necessary, finish to norm level of a cooling liquid.
5. Adjust turns of idling and the maintenance WITH in exhaust gases.

On the main page