Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
- 6. Fuel and exhaust systems
- 6.1. Models with the carburettor
6.1.1. A technical characteristics
6.1.2. Use unleaded gasoline
6.1.3. Removal and installation of the case of the air filter
6.1.4. System of adjustment of temperature of air arriving in the engine
6.1.5. Check, removal and installation of the fuel pump
6.1.6. Removal and installation of the gauge of level of fuel
6.1.7. Removal and installation of a fuel tank
6.1.8. Removal, installation and adjustment of a cable of an accelerator
6.1.9. Removal and installation of a pedal of an accelerator
6.1.10. Removal, installation and adjustment of a cable of management air заслонкой
+ 6.1.11. Carburettors
6.1.12. Check of the electromagnetic valve of a stopping delivery of fuel
6.1.13. Removal and carburettor installation
+ 6.1.14. Carburettor repair
6.1.15. Removal and installation of an inlet collector
6.1.16. Removal and installation of a final collector
6.1.17. Removal and installation of a heater of an inlet collector
6.1.18. Removal and exhaust system installation
+ 6.2. Models with system of injection of fuel
+ 6.3. Models with engines 16D and 16DA
+ 6.4. Models with engines 17D and 17DR
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes
|
Check
| PERFORMANCE ORDER |
| 1. Disconnect wires from a primary winding of the coil of ignition. |
| 2. Remove a hose from a target branch pipe of the fuel pump. |
| 3. Wind a target branch pipe of the fuel pump with pure rags. The assistant should turn a cranked shaft a starter. Thus the entrance branch pipe should leave fuel strong, equal pushes. Absence of fuel testifies or to malfunction of the fuel pump, or about absence of fuel in a fuel tank. |
| 4. If the fuel pump is faulty, it is necessary to replace it, as repair of the fuel pump is not provided. |
|
Removal
| PERFORMANCE ORDER |
| 1. Remove a wire of weight from the accumulator. |
|
|
2. Disconnect fuel hoses (And – entrance, In – pressure head) from the fuel pump. If necessary mark hoses and close their suitable stoppers. |
|
|
3. Unscrew nuts or bolts and remove the pump from the engine. Remove linings. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is made in sequence, return to removal. At installation use new linings. |
| 2. Start the engine and check up fuel system on presence of leaks. In the presence of leaks immediately switch off the engine and eliminate leak. At installation of the fuel pump engine start can longer last the usual. |
|
|
On the main page
|