Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
- 6. Fuel and exhaust systems
   - 6.1. Models with the carburettor
      6.1.1. A technical characteristics
      6.1.2. Use unleaded gasoline
      6.1.3. Removal and installation of the case of the air filter
      6.1.4. System of adjustment of temperature of air arriving in the engine
      6.1.5. Check, removal and installation of the fuel pump
      6.1.6. Removal and installation of the gauge of level of fuel
      6.1.7. Removal and installation of a fuel tank
      6.1.8. Removal, installation and adjustment of a cable of an accelerator
      6.1.9. Removal and installation of a pedal of an accelerator
      6.1.10. Removal, installation and adjustment of a cable of management air заслонкой
      + 6.1.11. Carburettors
      6.1.12. Check of the electromagnetic valve of a stopping delivery of fuel
      6.1.13. Removal and carburettor installation
      + 6.1.14. Carburettor repair
      6.1.15. Removal and installation of an inlet collector
      6.1.16. Removal and installation of a final collector
      6.1.17. Removal and installation of a heater of an inlet collector
      6.1.18. Removal and exhaust system installation
   + 6.2. Models with system of injection of fuel
   + 6.3. Models with engines 16D and 16DA
   + 6.4. Models with engines 17D and 17DR
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

6.1.15. Removal and installation of an inlet collector

Removal

PERFORMANCE ORDER
L models 1,2
1. The collector can be removed both with the carburettor, and without the carburettor. Disconnect from a collector a vacuum hose of the vacuum amplifier of brakes.
2. Unscrew three bolts (collector fastenings to a head of the block of cylinders are specified by arrows) and remove a collector and a lining.
Models 1,3, 1,4 and 1,6 l
3. Merge cooling liquid from cooling system.
4. Remove the generator.
5. Disconnect a pipe of system of cooling from an inlet collector and картера couplings.
6. On l models 1,3 disconnect an electric socket of the index of temperature of a cooling liquid.
7. Remove the carburettor.
8. Disconnect a vacuum hose of the vacuum amplifier of brakes.
9. Unscrew nuts and remove an inlet collector and a lining of an inlet collector.

Installation

PERFORMANCE ORDER
Installation is made in sequence, return to removal. Thus it is necessary to use a new lining. Tighten nuts and bolts of fastening of a collector the demanded moment. On models 1,3, 1,4 and 1,6 l fill in cooling liquid in cooling system. Adjust a tension auxiliary drive a generator belt.


On the main page