Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
- 6. Fuel and exhaust systems
   - 6.1. Models with the carburettor
      6.1.1. A technical characteristics
      6.1.2. Use unleaded gasoline
      6.1.3. Removal and installation of the case of the air filter
      6.1.4. System of adjustment of temperature of air arriving in the engine
      6.1.5. Check, removal and installation of the fuel pump
      6.1.6. Removal and installation of the gauge of level of fuel
      6.1.7. Removal and installation of a fuel tank
      6.1.8. Removal, installation and adjustment of a cable of an accelerator
      6.1.9. Removal and installation of a pedal of an accelerator
      6.1.10. Removal, installation and adjustment of a cable of management air заслонкой
      + 6.1.11. Carburettors
      6.1.12. Check of the electromagnetic valve of a stopping delivery of fuel
      6.1.13. Removal and carburettor installation
      + 6.1.14. Carburettor repair
      6.1.15. Removal and installation of an inlet collector
      6.1.16. Removal and installation of a final collector
      6.1.17. Removal and installation of a heater of an inlet collector
      6.1.18. Removal and exhaust system installation
   + 6.2. Models with system of injection of fuel
   + 6.3. Models with engines 16D and 16DA
   + 6.4. Models with engines 17D and 17DR
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes





6.1.8. Removal, installation and adjustment of a cable of an accelerator

Removal

PERFORMANCE ORDER
1. Remove the air filter.
2. Remove spring скобу and disconnect the spherical hinge of a cable of an accelerator from the lever throttle заслонки the carburettor.
3. Remove скобу, крепящую a cover of a cable of an accelerator to an arm on the carburettor, then remove a sealing ring from an arm.
4. In car salon remove a cable of an accelerator from a pedal for what move back a spring and, using the lever, take a cable of an accelerator from the groove end.
5. Take a sealing ring of a cable of an accelerator from a partition of a motor compartment. Take an accelerator cable in a motor compartment of the car.

Installation

Installation is made in sequence, return to removal.

Adjustment

PERFORMANCE ORDER
1. Check up that at completely pressed pedal of an accelerator throttle заслонка completely opens. Adjustment of a cable of an accelerator is made by shift скобы, крепящей a cover of a cable of an accelerator to a carburettor arm. Скоба, fixing a cover of a cable of an accelerator in an arm on the carburettor, it is intended for adjustment of sagging of a cable of an accelerator.
2. On models 1,3 of l with the engine 13 NB check up that at completely drowned handle of management air заслонкой there is a small backlash (it is specified by an arrow) between the screw of adjustment of the accelerated turns of idling and a cam plate заслонки.

On the main page