Subaru Legacy/Outback

1999-2003 of release

Repair and car operation


Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
- Engine electric equipment
   Specifications
   Start of the engine from the auxiliary power supply
   Removal/installation, check and service of the storage battery
   Check of a condition and replacement of wires of the battery
   Ignition system - the general information and safety measures
   Check of serviceability of functioning of system of ignition
   Removal, installation and check of a condition of the module (it) of ignition
   Check and adjustment of installation of a corner of an advancing of ignition
   Replacement of gauges CKP, CMP and KS
   Service and replacement of spark plugs
   Check of a condition of high-voltage wires (4-cylinder engines)
   Charge system - the general information and safety measures
   Check of a condition of system of a charge
   The generator - the general information, check and service
   Removal, dismantling, assemblage and generator installation
   Start system - the general information and safety measures
   Check of serviceability of functioning of a starter and start chain
   Starter Nippondenso - check and service
   Starters Mitsubishi - check and service
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal, installation and check of a condition of the module (it) of ignition

4-cylinder models

Removal and installation

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Preliminary having marked, disconnect electroconducting from bobbin assemblage.

3. Turn out fixing bolts and remove the ignition module.

4. Installation is made upside-down, - fixing bolts tighten with demanded effort (6.4 Nanometers). Track correctness of connection of electroconducting, - the error at connection can lead to an exit of the module of ignition out of operation!

CHECK

 PERFORMANCE ORDER

1. At the switched off ignition disconnect electroconducting from bobbin assemblage and measure resistance between plugs №№ 1 and 2 and №№ 3 and 4 contact sockets. Compare results of measurements to requirements of Specifications. Considerably underestimated indications testify to short circuit presence.

2. For check of a secondary contour measure resistance between target plugs of the module of ignition (А-В and С-D).


3. Having measured resistance between the primary plug and the assemblage case (demanded value makes not less than 10 МОм), estimate also an isolation condition
4. The faulty coil is subject to replacement.

6-cylinder models

 PERFORMANCE ORDER

1. As in system of direct ignition (DIS) 6-cylinder engines individual bobbin modules are used, the description of procedures of their removal and installation see in Section Service and replacement of spark plugs. A tightening of fixing bolts it is necessary to make of 16 Nanometers with effort.
2. The procedure for test of bobbin assemblages is stated in Section Check of serviceability of functioning of system of ignition.


On the main page