Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
- Engine electric equipment
Specifications
Start of the engine from the auxiliary power supply
Removal/installation, check and service of the storage battery
Check of a condition and replacement of wires of the battery
Ignition system - the general information and safety measures
Check of serviceability of functioning of system of ignition
Removal, installation and check of a condition of the module (it) of ignition
Check and adjustment of installation of a corner of an advancing of ignition
Replacement of gauges CKP, CMP and KS
Service and replacement of spark plugs
Check of a condition of high-voltage wires (4-cylinder engines)
Charge system - the general information and safety measures
Check of a condition of system of a charge
The generator - the general information, check and service
Removal, dismantling, assemblage and generator installation
Start system - the general information and safety measures
Check of serviceability of functioning of a starter and start chain
Starter Nippondenso - check and service
Starters Mitsubishi - check and service
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Check and adjustment of installation of a corner of an advancing of ignition
4-cylinder models
|
|
|
|
Be careful, - try not to burn about hot surfaces of the heated-up engine to normal working temperature! |
1. In systems of direct ignition (DIS) the corner of an advancing of ignition is exposed automatically and to adjustment is not subject, however in case of need corner installation can be checked up.
2. Warm up the engine to normal working temperature.
3. Operating according to instructions of manufacturers, connect a stroboscope to ВВ to a wire of a spark plug of the first cylinder.
|
|
4. Start the engine on single turns. Tracing of frequency of rotation of the engine can be made both on built in a combination of devices, and on дистанционно connected, - operate according to instructions of manufacturers, - to a tachometre. Highlighting a stroboscope an adjusting scale, on a site of a basic label define value of a corner of an advancing of ignition. Compare results of measurement to the data resulted in Specifications. At negative results of check it is necessary to make testing of a control system by the engine. |
|
|
6-cylinder models
|
|
|
1. Before starting procedure performance estimate a condition of a filtering element of an air cleaner and spark plugs, check up correctness of connection of vacuum hoses and make sure that the control lamp of refusals (MIL / «does not burn Check up the engine»).
2. Start the engine and warm up it to normal working temperature, then muffle.
3. Fill in firm input reader Subaru (SSM) a cartridge, then connect the device to located at the left under the panel of devices to diagnostic socket DLC.
4. Turn a key in the ignition lock in position «ON» and include food SSM.
5. Choose in the main menu (Main Menu) the input reader point {2. Each System Check}, then pass in a bookmark {Engine Control System} and further: {1. Current Data Display and Save} and {1.12 Data Display}.
6. Start the engine on single turns (tracing of frequency of rotation of the engine can be made both on built in a combination of devices, and on дистанционно to a connected tachometre) and check up value of a corner of an advancing of ignition. Compare results of measurement to the data resulted in Specifications (10 ° ± 3 ° before ВМТ at 600 rpm). At negative results of check it is necessary to make testing of systems |
|
|
On the main page
|