Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual box and differential
- Automatic transmission
Specifications
Electrohydraulic control system - the general information, appointment of basic elements
Self-diagnostics system - the general information and functioning principles
Diagnostics of general condition АТ
Problem diagnostics АТ
Removal and installation трансмиссионной assemblages
Replacement of elements of a suspension bracket трансмиссионной assemblages
Replacement of an epiploon of a casing of lengthening АТ
Condition check, adjustment and replacement of the gauge-switch of the permission of start
Removal and installation of the forward gauge of speed (VSS)
Removal and installation of the back gauge of speed (VSS)
Removal and installation of the gauge of turns of the turbine of the hydrotransformer
Removal, service and installation клапанной assemblages
Replacement of electromagnetic valves of switching, executive electromagnetic valves and the gauge of temperature ATF
Filter ATF replacement
Removal and installation of the module of management of transmission (TCM)
Removal, installation and check of a condition of lines of a path of cooling ATF
Removal, service and installation of components of the lever of selector AT
Removal, installation, check of a condition and adjustment drive selector AT cable
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal, installation, check of a condition and adjustment drive selector AT cable
Adjustment of a cable of the selector
|
|
A — Forward
B — the selector Lever
C — the Connecting link
D — the Adjusting nut In |
E — a contact Point
F — the Adjusting nut And |
Removal and installation
|
|
|
1. Tyre out the car on the lift.
2. Translate the selector lever in position «N».
3. Lift the car.
4. Remove reception, central and back section of system of release of the fulfilled gases in gathering with the muffler (see the Head of the Power supply system and release).
5. Uncover a thermofilter.
6. Take шплинт and remove a washer from fastening knot drive a cable to the executive lever of a choice of ranges.
7. Remove assemblage of a plate from the transmission case.
8. Disconnect a cable from the lever of the selector and remove a basic arm of a cable.
9. Remove a cable of the selector from plate assemblage.
10. Installation is made in an order, the return to an order of dismantle of components. Track, that all fixture has been tightened with demanded effort. In summary adjust a cable of the selector and check up serviceability of functioning of the lever of the selector. |
|
CHECK
|
|
|
1. Check up a cover condition тросовой assemblages and, make sure of absence of traces of development of corrosion of the core, estimate smoothness of a course of the removed cable, in case of need make replacement тросовой assemblages.
2. Translate the lever of the selector from position «P» in position «1». In each position the lever should be fixed, - in case of need make cable adjustment (see further). |
|
ADJUSTMENT
|
|
|
1. Establish the selector lever in position «N».
2. Remove back section of system of release of the fulfilled gases in gathering with the muffler (see the Head of the Power supply system and release).
3. Uncover a thermofilter.
4. Release adjusting nuts And.
|
|
5. Rotate an adjusting nut In while it will not concern a connecting link. |
6. Keeping an adjusting nut In from rotation by the second key, tighten an adjusting nut And with demanded effort (7.5 nanometers).
7. Make sure of serviceability of functioning of the lever of the selector.
8. Establish the removed components, operating in an order, the return to an order of their dismantle.
|
|
|
On the main page
|