Subaru Legacy/Outback

1999-2003 of release

Repair and car operation



Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual box and differential
- Automatic transmission
   Specifications
   Electrohydraulic control system - the general information, appointment of basic elements
   Self-diagnostics system - the general information and functioning principles
   Diagnostics of general condition АТ
   Problem diagnostics АТ
   Removal and installation трансмиссионной assemblages
   Replacement of elements of a suspension bracket трансмиссионной assemblages
   Replacement of an epiploon of a casing of lengthening АТ
   Condition check, adjustment and replacement of the gauge-switch of the permission of start
   Removal and installation of the forward gauge of speed (VSS)
   Removal and installation of the back gauge of speed (VSS)
   Removal and installation of the gauge of turns of the turbine of the hydrotransformer
   Removal, service and installation клапанной assemblages
   Replacement of electromagnetic valves of switching, executive electromagnetic valves and the gauge of temperature ATF
   Filter ATF replacement
   Removal and installation of the module of management of transmission (TCM)
   Removal, installation and check of a condition of lines of a path of cooling ATF
   Removal, service and installation of components of the lever of selector AT
   Removal, installation, check of a condition and adjustment drive selector AT cable
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Replacement of an epiploon of a casing of lengthening АТ

 PERFORMANCE ORDER

1. Make sure of absence of leaks ATF around an input in transmission карданного a shaft. In case of need replace an epiploon of a casing of lengthening АТ (see further).
2. Carefully clear transmission outside.
3. Turn out a drain stopper and merge ATF, then wrap a stopper into place and tighten it with demanded effort.
4. Remove assemblage of back section of system of release of the fulfilled gases with the muffler.
5. Uncover a thermofilter.
6. Remove карданный a shaft (Coupling see the Head).
7. By means of stripper ST 398527700 take an old epiploon.
8. With the help оправки ST 498057300 plant a new epiploon in the case of lengthening of transmission.
9. The further installation is made upside-down. Track, that all fixture has been tightened with demanded effort.


On the main page