Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
- 11. Brake system
   11.1. A technical characteristics
   + 11.2. Prorolling of hydraulic brake system
   11.3. Brake pipelines and hoses
   + 11.4. Lobbies brake Pads
   11.5. Replacement back brake колодок on disk brakes
   11.6. Replacement back brake колодок on drum-type brakes
   11.7. Check, removal and installation of a forward brake disk
   11.8. Check, removal and installation of a back brake disk
   11.9. Removal, check and installation of a brake drum
   + 11.10. A support of a forward brake
   + 11.11. A support of a back disk brake
   + 11.12. The back working brake cylinder
   + 11.13. The main brake cylinder
   + 11.14. Valves of adjustment of pressure
   11.15. Replacement of the unidirectional valve of the vacuum amplifier of brakes
   11.16. Check, removal and installation of the vacuum amplifier of brakes
   11.17. Removal and installation of a pedal of a brake
   11.18. Removal and installation of a cable of a manual brake
   11.19. Removal and installation of the lever of a manual brake
   11.20. Replacement brake колодок a manual brake on back disk brakes
   + 11.21. Antiblocking system of brakes (ABS)
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes





11.15. Replacement of the unidirectional valve of the vacuum amplifier of brakes
THE GENERAL DATA

The vacuum plastic hose is not intended for a reuse, therefore at replacement of the valve also it is necessary to replace a hose.

PERFORMANCE ORDER
1. Unscrew a connecting nut, крепящую a hose to an inlet collector.
2. Having pulled, remove a connector of a cranked branch pipe from the vacuum amplifier of brakes.
3. Cut off a hose from the unidirectional valve and connectors of a cranked branch pipe and a collector.
4. Cut off a new hose of the demanded length.
5. Connect a hose to the unidirectional valve and a connector and fix its collars.
6. Check up that arrows on the valve specify in a collector.
7. Connect муфты to a collector and the vacuum amplifier of brakes.

On the main page