Opel Kadett E

1984-1991 of release

Repair and car operation


Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
- 11. Brake system
   11.1. A technical characteristics
   + 11.2. Prorolling of hydraulic brake system
   11.3. Brake pipelines and hoses
   + 11.4. Lobbies brake Pads
   11.5. Replacement back brake колодок on disk brakes
   11.6. Replacement back brake колодок on drum-type brakes
   11.7. Check, removal and installation of a forward brake disk
   11.8. Check, removal and installation of a back brake disk
   11.9. Removal, check and installation of a brake drum
   + 11.10. A support of a forward brake
   + 11.11. A support of a back disk brake
   + 11.12. The back working brake cylinder
   + 11.13. The main brake cylinder
   + 11.14. Valves of adjustment of pressure
   11.15. Replacement of the unidirectional valve of the vacuum amplifier of brakes
   11.16. Check, removal and installation of the vacuum amplifier of brakes
   11.17. Removal and installation of a pedal of a brake
   11.18. Removal and installation of a cable of a manual brake
   11.19. Removal and installation of the lever of a manual brake
   11.20. Replacement brake колодок a manual brake on back disk brakes
   + 11.21. Antiblocking system of brakes (ABS)
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

11.9. Removal, check and installation of a brake drum

Removal

PERFORMANCE ORDER
1. At presence remove a wheel cap, then ослабьте bolts of fastening of a back wheel.
2. Lift a back part of the car and fix on supports.
3. Remove a back wheel.
4. Release a manual brake.
5. Unscrew the screw of fastening of a brake drum and remove a brake drum.
6. If the brake drum is kept brake колодками, remove заглушку from an aperture in a brake board and, using a screw-driver, move a control lever of a manual brake to brake колодке that brake Pads have departed from a drum.

Check

PERFORMANCE ORDER
1. Being careful, clear an internal surface of a brake drum of a brake dust and a dirt.
2. Clear an external surface of a brake drum and check up on obvious signs of deterioration or damage, and also presence of cracks round apertures under bolts of fastening of a wheel.
3. If necessary replace a drum.
4. Check up an internal part of a brake drum. Insignificant development of a drum from action brake колодок is the normal phenomenon. The drum repoint is not recommended.

Installation

PERFORMANCE ORDER
1. At installation of a new brake drum remove from its surface a sheeting layer.
2. Check up and, if necessary, clear interfaced surfaces of a brake drum and a nave.
3. Reduce length of an adjusting lath brake колодок, rotating an adjusting wheel of a lath.
4. Establish a brake drum and fix its screw.
5. Some times press a brake pedal to put in action the mechanism of adjustment of a backlash brake колодок.
6. If necessary adjust a manual brake.
7. Establish a wheel and lower the car.
8. Tighten bolts of fastening of a wheel the demanded moment.


On the main page