Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
- 11. Brake system
   11.1. A technical characteristics
   + 11.2. Prorolling of hydraulic brake system
   11.3. Brake pipelines and hoses
   + 11.4. Lobbies brake Pads
   11.5. Replacement back brake колодок on disk brakes
   11.6. Replacement back brake колодок on drum-type brakes
   11.7. Check, removal and installation of a forward brake disk
   11.8. Check, removal and installation of a back brake disk
   11.9. Removal, check and installation of a brake drum
   - 11.10. A support of a forward brake
      11.10.1. Support removal
      + 11.10.2. Support repair
      11.10.3. Support installation
   + 11.11. A support of a back disk brake
   + 11.12. The back working brake cylinder
   + 11.13. The main brake cylinder
   + 11.14. Valves of adjustment of pressure
   11.15. Replacement of the unidirectional valve of the vacuum amplifier of brakes
   11.16. Check, removal and installation of the vacuum amplifier of brakes
   11.17. Removal and installation of a pedal of a brake
   11.18. Removal and installation of a cable of a manual brake
   11.19. Removal and installation of the lever of a manual brake
   11.20. Replacement brake колодок a manual brake on back disk brakes
   + 11.21. Antiblocking system of brakes (ABS)
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes





11.10. A support of a forward brake

11.10.1. Support removal
PERFORMANCE ORDER
1. At presence remove caps of wheels, then ослабьте bolts of fastening of forward wheels.
2. Tighten a manual brake, then lift a forward part of the car and fix on supports.
3. Remove forward wheels.
4. For reduction of losses of a brake liquid uncover with пополнительного a tank of brake system, close a mouth of a tank polyethylene and again screw a cover. It is necessary that the cover tightly closed пополнительный a tank.
5. Alternatively, using a clip, press the brake hose going to a support.
6. Clear area round connecting муфты a brake hose and a support.
7. Unscrew a connecting bolt, крепящий a brake hose to a back part of a support and disconnect from a support a hose.
8. Remove from a connecting bolt two sealing washers.
9. Close an aperture in a support and a brake hose suitable stoppers.
10. Remove brake Pads.
11. On models with early updatings of support АТЕ unscrew two bolts and remove a support from the car.
12. On models with supports GMF, using a screw-driver edge as the lever, remove dustproof caps from two bolts of fastening of the holder of a support.
13. Unscrew bolts of a bolt of fastening of a support.
14. Remove a support from a rotary fist.

On the main page