Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
- 11. Brake system
   11.1. A technical characteristics
   + 11.2. Prorolling of hydraulic brake system
   11.3. Brake pipelines and hoses
   + 11.4. Lobbies brake Pads
   11.5. Replacement back brake колодок on disk brakes
   11.6. Replacement back brake колодок on drum-type brakes
   11.7. Check, removal and installation of a forward brake disk
   11.8. Check, removal and installation of a back brake disk
   11.9. Removal, check and installation of a brake drum
   + 11.10. A support of a forward brake
   + 11.11. A support of a back disk brake
   + 11.12. The back working brake cylinder
   + 11.13. The main brake cylinder
   + 11.14. Valves of adjustment of pressure
   11.15. Replacement of the unidirectional valve of the vacuum amplifier of brakes
   11.16. Check, removal and installation of the vacuum amplifier of brakes
   11.17. Removal and installation of a pedal of a brake
   11.18. Removal and installation of a cable of a manual brake
   11.19. Removal and installation of the lever of a manual brake
   11.20. Replacement brake колодок a manual brake on back disk brakes
   + 11.21. Antiblocking system of brakes (ABS)
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

11.18. Removal and installation of a cable of a manual brake

Removal

PERFORMANCE ORDER
1. Unscrew an adjusting nut of the jack of cables of a manual brake and remove the jack.
2. On models with back drum-type brakes remove brake drums.
3. Release a cable of a manual brake from fastenings under the car bottom, a fuel tank and a back beam.
4. Disconnect cables of a manual brake from control levers of a manual brake. On models with back drum-type brakes levers are located on leaders brake колодках, and on models with back disk brakes levers are located in a back part of a brake board.
5. By means of a screw-driver remove a lock ring and take plastic plugs from brake boards.
6. Take a cable from brake boards and remove it.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.
2. Keep in mind that the cover of a cable of dark colour is established in the top part of the jack.
3. Adjust a manual brake.


On the main page