| 1. Unscrew two bolts, fastening a support of a back brake. |
| 2. Remove a brake support and, using a soft wire, tie up it to a back rack. Thus do not stretch and do not overwind a brake hose. |
|
3. Release a manual brake, then remove a protective cap of a nave. |
| 4. Take шплинт, fixing a nut of a nave from unscrewing. Unscrew a nut. |
|
5. Remove a brake disk / a nave from a fixing element of a nave. |
| 6. If the brake disk does not act in film, through an aperture in a brake board take away Pads a manual brake from a drum of a brake disk. |
| 7. Installation is made in sequence, return to removal taking into account following moments. |
| 8. At installation of a new brake disk remove from its surface a sheeting layer. |
| 9. Adjust bearings of a nave / of a brake disk. |
| 10. Use new шплинт for fastening of a nut of a nave. |
| 11. Adjust a manual brake. |