Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
- 11. Brake system
   11.1. A technical characteristics
   + 11.2. Prorolling of hydraulic brake system
   11.3. Brake pipelines and hoses
   + 11.4. Lobbies brake Pads
   11.5. Replacement back brake колодок on disk brakes
   11.6. Replacement back brake колодок on drum-type brakes
   11.7. Check, removal and installation of a forward brake disk
   11.8. Check, removal and installation of a back brake disk
   11.9. Removal, check and installation of a brake drum
   + 11.10. A support of a forward brake
   + 11.11. A support of a back disk brake
   + 11.12. The back working brake cylinder
   + 11.13. The main brake cylinder
   + 11.14. Valves of adjustment of pressure
   11.15. Replacement of the unidirectional valve of the vacuum amplifier of brakes
   11.16. Check, removal and installation of the vacuum amplifier of brakes
   11.17. Removal and installation of a pedal of a brake
   11.18. Removal and installation of a cable of a manual brake
   11.19. Removal and installation of the lever of a manual brake
   11.20. Replacement brake колодок a manual brake on back disk brakes
   + 11.21. Antiblocking system of brakes (ABS)
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes





11.17. Removal and installation of a pedal of a brake

Removal

PERFORMANCE ORDER
1. Disconnect an electric socket from the switch of stoplights (it is specified by an arrow), then turn the switch on 90 and remove it from an arm.
2. Disconnect a returnable spring from a brake pedal.
3. Remove spring скобу and take шарнирный a finger, крепящий a plug of a rod of the vacuum amplifier of brakes to a brake pedal.
4. Remove шплинт, fixing a nut of a shaft of a pedal of a brake.
5. Unscrew a nut from a shaft of a pedal of a brake and take a shaft to a steering column.
6. Remove a brake pedal.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.
2. At installation use new шплинт.
3. Grease all points of turns.
4. Before installation of the switch of stoplights as far as possible, extend a switch rod (above). After installation there will be a self-regulation of the switch of a stoplight (below).

On the main page