Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
- 11. Brake system
   11.1. A technical characteristics
   + 11.2. Prorolling of hydraulic brake system
   11.3. Brake pipelines and hoses
   + 11.4. Lobbies brake Pads
   11.5. Replacement back brake колодок on disk brakes
   11.6. Replacement back brake колодок on drum-type brakes
   11.7. Check, removal and installation of a forward brake disk
   11.8. Check, removal and installation of a back brake disk
   11.9. Removal, check and installation of a brake drum
   + 11.10. A support of a forward brake
   + 11.11. A support of a back disk brake
   - 11.12. The back working brake cylinder
      11.12.1. Cylinder removal
      11.12.2. Cylinder repair
      11.12.3. Cylinder installation
   + 11.13. The main brake cylinder
   + 11.14. Valves of adjustment of pressure
   11.15. Replacement of the unidirectional valve of the vacuum amplifier of brakes
   11.16. Check, removal and installation of the vacuum amplifier of brakes
   11.17. Removal and installation of a pedal of a brake
   11.18. Removal and installation of a cable of a manual brake
   11.19. Removal and installation of the lever of a manual brake
   11.20. Replacement brake колодок a manual brake on back disk brakes
   + 11.21. Antiblocking system of brakes (ABS)
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes





11.12. The back working brake cylinder

11.12.1. Cylinder removal
PERFORMANCE ORDER
1. At presence remove a wheel cap, then ослабьте bolts of fastening of a back wheel.
2. Lift a back part of the car and fix on supports.
3. Remove a back wheel.
4. Release a manual brake.
5. Unscrew the screw of fastening of a brake drum and remove a brake drum.
6. If the brake drum is kept brake колодками, remove заглушку from an aperture in a brake board and, using a screw-driver, move a control lever of a manual brake to brake колодке that brake Pads have departed from a drum.
7. If necessary ослабьте a tension of a cable of a manual brake.
8. Note an arrangement and, using flat-nose pliers, remove the top returnable spring compressing brake Pads.
9. Remove the top ends brake колодок from pistons of the working brake cylinder.
10. For reduction of losses of a brake liquid uncover with пополнительного a tank of brake system.
11. Close a mouth of a tank polyethylene and again screw a cover. It is necessary that the cover tightly closed пополнительный a tank.
11. Remove a dirt round a place of connection of a brake tube to a back part of the working brake cylinder.
12. Unscrew a connecting nut.
13. Being careful, take a brake tube from the working brake cylinder and close its stopper.
14. Unscrew two bolts of fastening of the working brake cylinder to a brake board and, being careful, remove the working brake cylinder.

On the main page