Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
- 11. Brake system
   11.1. A technical characteristics
   + 11.2. Prorolling of hydraulic brake system
   11.3. Brake pipelines and hoses
   + 11.4. Lobbies brake Pads
   11.5. Replacement back brake колодок on disk brakes
   11.6. Replacement back brake колодок on drum-type brakes
   11.7. Check, removal and installation of a forward brake disk
   11.8. Check, removal and installation of a back brake disk
   11.9. Removal, check and installation of a brake drum
   + 11.10. A support of a forward brake
   + 11.11. A support of a back disk brake
   + 11.12. The back working brake cylinder
   - 11.13. The main brake cylinder
      11.13.1. Removal and installation of the main brake cylinder
      + 11.13.2. Repair of the main brake cylinder (model without ABS)
   + 11.14. Valves of adjustment of pressure
   11.15. Replacement of the unidirectional valve of the vacuum amplifier of brakes
   11.16. Check, removal and installation of the vacuum amplifier of brakes
   11.17. Removal and installation of a pedal of a brake
   11.18. Removal and installation of a cable of a manual brake
   11.19. Removal and installation of the lever of a manual brake
   11.20. Replacement brake колодок a manual brake on back disk brakes
   + 11.21. Antiblocking system of brakes (ABS)
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

11.13. The main brake cylinder

11.13.1. Removal and installation of the main brake cylinder Removal

PERFORMANCE ORDER
1. Remove a wire of weight from the accumulator.
2. Press some times a brake pedal to fill with air the vacuum amplifier of brakes or to remove pressure in the hydraulic block of the servomotor.
3. Disconnect an electric socket from the gauge of level of a brake liquid in a cover of a jellied mouth пополнительного a tank.
4. Using a syringe, pump out a brake liquid from пополнительного a tank.
5. Arrange pure rags under the main brake cylinder to collect the leaked brake liquid.
6. Mark the brake tubes approaching to the main brake cylinder.
7. Unscrew nuts of fastening of brake tubes and take aside from the main brake cylinder brake tubes.
8. Close the ends of tubes corresponding stoppers.
9. Unscrew the valve of adjustment of pressure from the main brake cylinder.
10. Unscrew two nuts and remove the main brake cylinder from the vacuum amplifier of brakes together with a lining.
11. Clear an external surface of the main brake cylinder, then having pulled upwards, remove a tank from the main brake cylinder.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.
2. Thus establish a new lining and consolidation пополнительного a tank.
3. Remove air from hydraulic system.
4. Nuts of fastening of brake tubes should be tightened the demanded moment.
5. In case of pulling the flange on the tube end can be damaged.


On the main page