Subaru Legacy/Outback

1999-2003 of release

Repair and car operation


Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
- The engine
   Specifications
   Check компрессионного pressure in cylinders and tightness of the block
   Diagnostics of a condition of the engine with vacuum gauge application
   System of greasing of the engine - the general information
   - The procedures of the repair which has been not connected with extraction of the engine from the car, - four-cylinder engines
      Reduction of the piston of the first cylinder in position ВМТ
      Check and adjustment клапанных backlashes
      Removal and installation of a pulley of a cranked shaft
      Removal and installation of forward covers of drive ГРМ
      Removal and installation of a belt of drive ГРМ, check of a condition of components
      Removal, check of a condition and installation of cogwheels of camshafts
      Removal and installation of a cogwheel of a cranked shaft
      Натяжитель газораспределительного a belt - the general information and a functioning principle
      Removal, check of a condition and installation of elements of a drive of valves
      Removal and installation of camshafts
      Removal and installation of heads of cylinders
      Removal and pallet installation картера and маслозаборника
      Removal, service and installation of the oil pump
      Check of pressure of impellent oil
      Removal and installation of the gauge-switch of pressure of oil
      Removal, check of a condition and installation of a flywheel/privodnogo of a disk
      Replacement of support of a suspension bracket of the power unit
   + The procedures of the repair which has been not connected with extraction of the engine from the car, - six-cylinder engines
   + The general and major repairs of engines
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Replacement of support of a suspension bracket of the power unit

Design and details of installation of support of a suspension bracket of the power unit

1 — the Pillow of a forward support (model 2.0)
2 — the Arm of a forward support (model 2.0)
3 — the Pillow of a forward support (model 2.5)

Efforts of a tightening of carving connections, Nanometer

Т1: 34
Т2: 41
Т3: 85


 PERFORMANCE ORDER

1. The scheme of the organisation of a suspension bracket of the power unit is presented on illustrations.

1 — the Rubber pillow
2 — Arms

1 — the Pillow

2. A design and details of installation of support of a suspension bracket of the power unit are shown on an illustration.
3. Remove the power unit (see Has undressed Removal of the power unit from the car - performance and safety measure methods).
4. Remove support from the unit and attentively check up rubber pillows on presence of signs of ageing of a material, deformations, cracks and other mechanical damages.
5. Installation is made upside-down.


On the main page