Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
- 11. Brake system
   11.1. A technical characteristics
   + 11.2. Prorolling of hydraulic brake system
   11.3. Brake pipelines and hoses
   + 11.4. Lobbies brake Pads
   11.5. Replacement back brake колодок on disk brakes
   11.6. Replacement back brake колодок on drum-type brakes
   11.7. Check, removal and installation of a forward brake disk
   11.8. Check, removal and installation of a back brake disk
   11.9. Removal, check and installation of a brake drum
   + 11.10. A support of a forward brake
   + 11.11. A support of a back disk brake
   - 11.12. The back working brake cylinder
      11.12.1. Cylinder removal
      11.12.2. Cylinder repair
      11.12.3. Cylinder installation
   + 11.13. The main brake cylinder
   + 11.14. Valves of adjustment of pressure
   11.15. Replacement of the unidirectional valve of the vacuum amplifier of brakes
   11.16. Check, removal and installation of the vacuum amplifier of brakes
   11.17. Removal and installation of a pedal of a brake
   11.18. Removal and installation of a cable of a manual brake
   11.19. Removal and installation of the lever of a manual brake
   11.20. Replacement brake колодок a manual brake on back disk brakes
   + 11.21. Antiblocking system of brakes (ABS)
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes





11.12.3. Cylinder installation
PERFORMANCE ORDER
1. Establish the working brake cylinder on a brake board and fix bolts.
2. Connect a brake tube to the working brake cylinder and fix a connecting nut.
3. Establish brake Pads on pistons of the brake cylinder and establish the top returnable spring.
4. Establish a brake drum and fix its screw.
5. If necessary, rotating a wheel of an adjusting lath, take away brake Pads from a drum.
6. Remove polyethylene from a jellied mouth пополнительного a tank of brake system and pump over a corresponding brake contour.
7. Adjust a backlash between brake колодками and a drum for what some times press a brake pedal. By pedal pressing at normal work of an adjusting lath the clicks published by an adjusting lath should be audible.
8. Establish a wheel and lower the car on the earth.
9. Tighten bolts of fastening of a wheel the demanded moment.

On the main page