Subaru Legacy/Outback

1999-2003 of release

Repair and car operation



Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
- The engine
   Specifications
   Check компрессионного pressure in cylinders and tightness of the block
   Diagnostics of a condition of the engine with vacuum gauge application
   System of greasing of the engine - the general information
   + The procedures of the repair which has been not connected with extraction of the engine from the car, - four-cylinder engines
   - The procedures of the repair which has been not connected with extraction of the engine from the car, - six-cylinder engines
      Reduction of the piston of the first cylinder in position ВМТ
      Check and adjustment клапанных backlashes
      Removal and installation of a pulley of a cranked shaft
      Removal and installation of covers of drive ГРМ
      Removal and installation газораспределительных chains
      Removal and installation of asterisks of a drive of camshafts
      Removal and installation of an asterisk of a cranked shaft
      Automatic натяжитель газораспределительной chains - the general information
      Removal and installation of camshafts
      Removal and installation of heads of cylinders
      Removal and installation of the bottom section of the pallet картера and маслозаборника
      Removal, service and installation of the oil pump
      Service редукционного the valve of the oil pump
      Check of pressure of impellent oil
      Removal and installation of the gauge-switch of pressure of oil
      Removal and installation маслоохладителя
      Removal and installation drive a disk
      Replacement of support of a suspension bracket of the power unit
   + The general and major repairs of engines
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of the bottom section of the pallet картера and маслозаборника

REMOVAL

 PERFORMANCE ORDER

 The top pallet картера cannot be removed at normal position of the car - the engine should be separated from the case.


1. Поддомкратьте the car also establish it on props.
2. Remove protection картера.

3. Get under the car suitable capacity and merge impellent oil, having turned out from the pallet картера a drain stopper.

4. Turn out fixing bolts, then by means of the special adaptation separate the bottom section of the pallet from the top.

 Do not try to hook at all the pallet a screw-driver or mount, - use only the special adaptation with a cutting edge!

5. Remove equipped with the mesh filter маслоприемник.

INSTALLATION

 PERFORMANCE ORDER

1. Before installation make sure of absence of damages of the pallet картера, the mesh filter, a basic arm маслозаборника and дефлекторной plates.

 Before pallet installation carefully smooth out corresponding interfaced surfaces, completely having removed from them traces of a material of old hermetic.
2. Fix маслозаборник on дефлекторной to a plate. Tighten fixing bolts with demanded effort (6.4 Nanometers).

 Replace a sealing ring with the new.


3. Put on an interfaced surface of the pallet картера hermetic of type Three Bond 1280В in diameter 5.0 ± 1.0 mm in section.

 The hermetic pillow should be imposed from the inside болтовых apertures. Press the bottom section of the pallet to top, screw fixing bolts and tighten them with demanded effort (6.4 Nanometers).

4. Establish protection картера, lower the car on the earth and fill in impellent oil.


On the main page