Subaru Legacy/Outback

1999-2003 of release

Repair and car operation


Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
- The engine
   Specifications
   Check компрессионного pressure in cylinders and tightness of the block
   Diagnostics of a condition of the engine with vacuum gauge application
   System of greasing of the engine - the general information
   + The procedures of the repair which has been not connected with extraction of the engine from the car, - four-cylinder engines
   - The procedures of the repair which has been not connected with extraction of the engine from the car, - six-cylinder engines
      Reduction of the piston of the first cylinder in position ВМТ
      Check and adjustment клапанных backlashes
      Removal and installation of a pulley of a cranked shaft
      Removal and installation of covers of drive ГРМ
      Removal and installation газораспределительных chains
      Removal and installation of asterisks of a drive of camshafts
      Removal and installation of an asterisk of a cranked shaft
      Automatic натяжитель газораспределительной chains - the general information
      Removal and installation of camshafts
      Removal and installation of heads of cylinders
      Removal and installation of the bottom section of the pallet картера and маслозаборника
      Removal, service and installation of the oil pump
      Service редукционного the valve of the oil pump
      Check of pressure of impellent oil
      Removal and installation of the gauge-switch of pressure of oil
      Removal and installation маслоохладителя
      Removal and installation drive a disk
      Replacement of support of a suspension bracket of the power unit
   + The general and major repairs of engines
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal, service and installation of the oil pump

REMOVAL

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Поддомкратьте the car also establish it on props.
3. Remove protection картера.
4. Empty cooling system.
5. Lower the car on the earth.
6. Remove a radiator (see the Head of System of cooling, heating).
7. Remove a V-shaped belt (Routine maintenance see the Head).
8. Remove a forward cover of drive ГРМ (see Has undressed Removal and installation of covers of drive ГРМ).
9. Remove газораспределительную a chain (see Has undressed Removal and installation газораспределительных chains).

10. Remove an asterisk of a cranked shaft and a cover of the oil pump (see Has undressed Removal and installation of an asterisk of a cranked shaft).

11. Take external and internal rotors of pump assemblage.

CHECK

See Has undressed Removal, service and installation of the oil pump.

INSTALLATION

 PERFORMANCE ORDER

1. Dip both rotors into a bath with impellent oil.
2. Plant an internal rotor on a pin of a cranked shaft, and then establish an external rotor.

3. Establish a cover of the oil pump and, operating strictly in a certain order, tighten bolts of its fastening with demanded effort (6.4 Nanometers), - track, that all bolts have been established on the regular places.

4. Establish an asterisk of a cranked shaft.
5. The further installation is made in an order, the return to an order of dismantle of components.


On the main page