Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
- The engine
Specifications
Check компрессионного pressure in cylinders and tightness of the block
Diagnostics of a condition of the engine with vacuum gauge application
System of greasing of the engine - the general information
+ The procedures of the repair which has been not connected with extraction of the engine from the car, - four-cylinder engines
- The procedures of the repair which has been not connected with extraction of the engine from the car, - six-cylinder engines
Reduction of the piston of the first cylinder in position ВМТ
Check and adjustment клапанных backlashes
Removal and installation of a pulley of a cranked shaft
Removal and installation of covers of drive ГРМ
Removal and installation газораспределительных chains
Removal and installation of asterisks of a drive of camshafts
Removal and installation of an asterisk of a cranked shaft
Automatic натяжитель газораспределительной chains - the general information
Removal and installation of camshafts
Removal and installation of heads of cylinders
Removal and installation of the bottom section of the pallet картера and маслозаборника
Removal, service and installation of the oil pump
Service редукционного the valve of the oil pump
Check of pressure of impellent oil
Removal and installation of the gauge-switch of pressure of oil
Removal and installation маслоохладителя
Removal and installation drive a disk
Replacement of support of a suspension bracket of the power unit
+ The general and major repairs of engines
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Automatic натяжитель газораспределительной chains - the general information
Components automatic натяжителя газораспределительной chains
The design automatic натяжителя газораспределительной is shown a chain on an illustration.
Left and right приводные chains are equipped individual натяжителями. Натяжители hydraulic type use pressure of impellent oil and are capable to support automatically a tension drivers chains in the set range, excluding thereby requirement for manual adjustment.
In the case натяжителя there is an oil aperture which on established натяжителе is joined to a corresponding aperture in the block of cylinders. In the case натяжителя the chamber of a high pressure with a control ball is located. Pressure in the chamber is regulated редукционным by the valve. Thanking плунжеру with an external carving натяжитель it is capable to keep a tightness приводной chains at the set level even at the muffled engine. |
On the main page
|