Subaru Legacy/Outback

1999-2003 of release

Repair and car operation



Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
- The engine
   Specifications
   Check компрессионного pressure in cylinders and tightness of the block
   Diagnostics of a condition of the engine with vacuum gauge application
   System of greasing of the engine - the general information
   + The procedures of the repair which has been not connected with extraction of the engine from the car, - four-cylinder engines
   - The procedures of the repair which has been not connected with extraction of the engine from the car, - six-cylinder engines
      Reduction of the piston of the first cylinder in position ВМТ
      Check and adjustment клапанных backlashes
      Removal and installation of a pulley of a cranked shaft
      Removal and installation of covers of drive ГРМ
      Removal and installation газораспределительных chains
      Removal and installation of asterisks of a drive of camshafts
      Removal and installation of an asterisk of a cranked shaft
      Automatic натяжитель газораспределительной chains - the general information
      Removal and installation of camshafts
      Removal and installation of heads of cylinders
      Removal and installation of the bottom section of the pallet картера and маслозаборника
      Removal, service and installation of the oil pump
      Service редукционного the valve of the oil pump
      Check of pressure of impellent oil
      Removal and installation of the gauge-switch of pressure of oil
      Removal and installation маслоохладителя
      Removal and installation drive a disk
      Replacement of support of a suspension bracket of the power unit
   + The general and major repairs of engines
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal and installation of a pulley of a cranked shaft

 PERFORMANCE ORDER

1. Uncover a pulley of a cranked shaft.

2. Turn out a bolt of a pulley of a cranked shaft, - for blocking of a shaft from проворачивания take advantage of adaptation ST 49997100.

3. Remove a pulley of a cranked shaft.
4. Installation is made in an order, the return to an order of dismantle of components. Before installation of a bolt of a pulley of a cranked shaft blow a carving of a fixing aperture the compressed air. A carving part of a bolt and a persistent surface of its head grease with impellent oil. Track, that the bolt has been tightened with demanded effort (178 Nanometers). Bolts of fastening of a cover of a pulley tighten with effort of 6.4 Nanometers.
5. Having finished installation, start the engine and check up a pulley cover on presence of signs of development of leaks.

On the main page