Subaru Legacy/Outback

1999-2003 of release

Repair and car operation



Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
- The engine
   Specifications
   Check компрессионного pressure in cylinders and tightness of the block
   Diagnostics of a condition of the engine with vacuum gauge application
   System of greasing of the engine - the general information
   + The procedures of the repair which has been not connected with extraction of the engine from the car, - four-cylinder engines
   - The procedures of the repair which has been not connected with extraction of the engine from the car, - six-cylinder engines
      Reduction of the piston of the first cylinder in position ВМТ
      Check and adjustment клапанных backlashes
      Removal and installation of a pulley of a cranked shaft
      Removal and installation of covers of drive ГРМ
      Removal and installation газораспределительных chains
      Removal and installation of asterisks of a drive of camshafts
      Removal and installation of an asterisk of a cranked shaft
      Automatic натяжитель газораспределительной chains - the general information
      Removal and installation of camshafts
      Removal and installation of heads of cylinders
      Removal and installation of the bottom section of the pallet картера and маслозаборника
      Removal, service and installation of the oil pump
      Service редукционного the valve of the oil pump
      Check of pressure of impellent oil
      Removal and installation of the gauge-switch of pressure of oil
      Removal and installation маслоохладителя
      Removal and installation drive a disk
      Replacement of support of a suspension bracket of the power unit
   + The general and major repairs of engines
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Replacement of support of a suspension bracket of the power unit

The device of support of a suspension bracket of the power unit on l models 3.0

1 — the Diaphragm
2 — the Air chamber
3 — the Liquid chamber

4 — the Throttle aperture
5 — the Membrane
6 — the Rubber pillow


Design and details of installation of support of a suspension bracket of the power unit

1 — Rubber pillows

Efforts of a tightening of carving connections, Nanometer

Т1: 34
Т2: 74


 PERFORMANCE ORDER

1. Engine H6 is supported by specially developed elastic support filled with a liquid. Each support is rigidly attached to the engine in three points. Support are capable to reduce effectively level of vibrations and noise thanks to presence of the membrane established between two chambers filled by a liquid. The similar design allows to reduce a springing constant of a support.
2. A design and details of installation of support of a suspension bracket of the power unit are shown on an illustration.
3. Remove the power unit (see Has undressed Removal of the power unit from the car - performance and safety measure methods).
4. Remove support from the unit and attentively check up rubber pillows on presence of signs of ageing of a material, deformations, cracks and other mechanical damages.
5. Installation is made upside-down.


On the main page