Replacement of batteries of a key of remote control
REMOVAL
ATTENTION At removal of batteries check up, whether polarity is specified on batteries. If polarity is not specified, mark battery position.
| PERFORMANCE ORDER |
| 1. Insert a screw-driver into a backlash between the block of the transmitter–1 and the main key–2. |
| 2. Turn a screw-driver in an arrow direction and by that disconnect the block of the transmitter from a key. |
| 3. Release the transmitter block, having pressed lateral clamps (are specified by arrows). Remove the transmitter block. | | 4. Disconnect the top battery–1 by means of a screw-driver from holders–2, as shown arrows. | | 5. Take out a contact plate–1. Thus turn it so that two direct edges adjoined to both clamps. The contact plate can be removed also by means of a screw-driver. | | 6. Disconnect the bottom battery by means of a screw-driver from holders. | | INSTALLATION
ATTENTION
At installation of batteries watch polarity. Polarity (+/–) is specified on the battery and the case.
| PERFORMANCE ORDER |
| 1. Insert the bottom battery–4 positive pole (+) downwards into the case–5. The positive pole (+) is specified on the case. | | 2. Put a contact plate–3 on the battery–4 and turn behind clamps. |
| 3. Put the battery–2 positive pole (+) downwards on a contact plate and fix. | 4. Put the block of the transmitter–1 on the case–2 and fix.
ATTENTION
The transmitter block is shown on an illustration turned.
|
5. Insert the complete block of the transmitter into the main key–6 and fix.
ATTENTION The key has транспондер the variable code, designated by beaten out letter W.
|
| | |
|