Audi A3

Since 1997 of release

Repair and car operation

Removal and control panel installation

THE GENERAL DATA

Sockets on a control panel underside

And – a socket 32 contacts, dark blue
In – a socket 32 contacts, green
With – a socket of 20 contacts, red. Only execution «Higline»
1 – a control lamp of a headlight, 1.2 Vt

2 – a control lamp антипробуксовочной systems ASR, 1.2 Vt (the additional equipment)
3 – a control lamp of the index of turn of the trailer, 1.2 Vt

In a control panel control lamps which are lamps накаливания can be replaced only. In the presence of any other malfunctions in the block it is necessary to replace it entirely.

If it is necessary to replace a control panel, before removal it is necessary to consider the data from memory of malfunctions. Besides, by means of diagnostic device AUDI can be считаны and values of the index of intervals of service and a condition of the counter of run (work HUNDRED) are written down.

ATTENTION

Steering wheel removal is not required. On the subsequent illustrations the steering wheel for the best review is not shown.

REMOVAL

PERFORMANCE ORDER

1. Completely extend a steering wheel with the mechanism of adjustment and displace it downwards.
	2. Press sideways a cover–1 upwards and then extend a cover from the panel of devices.
	3. Turn out 2 screws with crosswise шлицем–1.
4. Take out forward a combination of devices.
5. Cut a connector of a cable from an underside of a combination of devices.
6. Release stoppers of the tip and separate штекерные connections with an underside of a combination of devices.
7. Replace the damaged lamps if it is possible.

INSTALLATION

PERFORMANCE ORDER

1. Installation is carried out in sequence, return to removal.
2. If the combination of devices was replaced, adjust the index of intervals of service and the counter of the passed distance (work HUNDRED).

On the main page