| 
 Audi A3
 +  The maintenance instruction
 +  Current leaving and service
 +  The engine
 +  Systems of cooling, heating
 +  The power supply system and release of the fulfilled gases
 +  Engine electric equipment
 +  Manual box of a gear change
 +  Automatic transmission and models with a full drive
 +  Coupling and power shafts
 +  Brake system
 +  Suspension bracket and steering
 +  Body
 -  Onboard electric equipment
 Electric equipment of system of comfort
 Diagnostics of malfunctions of an onboard electric equipment - the general information
 Check of the electric motor of a screen wiper
 Check of warmed back glass
 Stoplight check
 Removal, installation and check of a sound signal
 Safety locks
 Fusible inserts - the general information
 Chain breakers (thermal relays)
 The relay
 Replacement of batteries of a key of remote control
 Replacement of the battery/lamp of a key with illumination
 Anticreeping blocking
 Illumination devices
 Replacement of lamps of external illumination
 Replacement of bulbs of internal illumination
 Removal and headlight installation
 Removal and installation of the electric motor of adjustment of range of light
 Removal and installation of the forward index of turn
 Removal and installation of a back lantern
 Adjustment of light of headlights
 Devices
 Removal and control panel installation
 Removal and installation подрулевого the switch
 Removal and installation of switches and lamps
 Removal, installation and radio receiver coding
 Input of a code of a radio receiver
 Removal and loudspeaker installation
 Removal and installation of the aerial of a roof
 Additional installation of a radio telephone on in special way prepared models
 Removal and installation of the electric motor of a forward screen wiper
 Removal and installation of the lever and the electric motor of a back screen wiper
 Removal and installation of a cleaner of back glass
 Removal and installation of the tank from the pump стеклоомывателя
 Elements темпостата
 +  Electroschemes
 
 | 
 Illumination devicesIllumination devices concern: the main headlights, back lanterns, stoplights, backing lanterns, turn signals, illumination of licence plate and salon illumination.
 
 Replacement of lamps
 
 Lamps накаливания fail eventually. Therefore each 2 years they should be replaced on new even if they still keep the working capacity. It does not concern to галогенным to lamps which, for example, are applied in the main headlights. As a rule, their resource considerably above and to replace them follows only at failure. Easing of force of light in lamps накаливания is defined on black adjournment on a glass flask.
 
 Before replacement of a bulb of external illumination remove a wire of weight from the accumulator. Remember that if the bulb just burnt, it can be too hot.
 
 Before replacement of a bulb of external illumination check up a corresponding electric chain and a safety lock. Do not concern a glass flask of a lamp barehanded. The fingerprint evaporates and besieged on a reflector therefore illumination worsens. Necessarily replace the failed lamps with lamps of the same type. Stains arising on imprudence from touches wipe pure not a fleecy rag or spirit.
 
 At replacement of the xenon lamps it is necessary to be very attentive and cautious as from the power supply of these lamps it is possible to receive strong blow by a current.
 
 Replacement of gas-discharge (xenon) lamps which can be defined on a label with a high voltage sign on the lamp case, it is not recommended to make independently.
 
 ATTENTION
  In lamps накаливания Н7 an elevated pressure and they can burst at replacement, therefore at replacement of these lamps it is necessary to put on gloves and goggles.  
 | On the main page
 
 
 
 
 
 
 
 
 |