Audi A3

Since 1997 of release

Repair and car operation



Audi A3
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Manual box of a gear change
+ Automatic transmission and models with a full drive
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Electric equipment of system of comfort
   Diagnostics of malfunctions of an onboard electric equipment - the general information
   Check of the electric motor of a screen wiper
   Check of warmed back glass
   Stoplight check
   Removal, installation and check of a sound signal
   Safety locks
   Fusible inserts - the general information
   Chain breakers (thermal relays)
   The relay
   Replacement of batteries of a key of remote control
   Replacement of the battery/lamp of a key with illumination
   Anticreeping blocking
   Illumination devices
   Replacement of lamps of external illumination
   Replacement of bulbs of internal illumination
   Removal and headlight installation
   Removal and installation of the electric motor of adjustment of range of light
   Removal and installation of the forward index of turn
   Removal and installation of a back lantern
   Adjustment of light of headlights
   Devices
   Removal and control panel installation
   Removal and installation подрулевого the switch
   Removal and installation of switches and lamps
   Removal, installation and radio receiver coding
   Input of a code of a radio receiver
   Removal and loudspeaker installation
   Removal and installation of the aerial of a roof
   Additional installation of a radio telephone on in special way prepared models
   Removal and installation of the electric motor of a forward screen wiper
   Removal and installation of the lever and the electric motor of a back screen wiper
   Removal and installation of a cleaner of back glass
   Removal and installation of the tank from the pump стеклоомывателя
   Elements темпостата
+ Electroschemes





Check of warmed back glass

THE GENERAL DATA

At inclusion of heating of back glass the field with visible lines of wires should be released after a while from a covering or snow.

PERFORMANCE ORDER
1. In the presence of malfunctions check up at first a safety lock in the block of safety locks.
2. If the safety lock is perfectly in order, remove facing of back glass and check up reliability of connection of the tip at glass at the left and on the right. If necessary clear of corrosion.
3. If heating still does not work, check up the central monitor a comfort electric equipment, thus address also to subsection the Electric equipment of system of comfort.
4. If heater conductors are torn, it is possible to use a usual current-carrying varnish for repair. For this purpose clear the damaged place a thinner or этиленом.
5. Paste over the damaged place from both parties with a gluing tape and put a small brush a current-carrying varnish.
6. Dry a paint at temperature nearby +25С within 24 hours. For this purpose it is possible to apply also hot air. At temperature +150С the paint dries up within 30 minutes
ATTENTION

Do not include heating of back glass before the paint completely will not dry up. To clearing of the damaged elements do not apply gasoline or other solvents.


On the main page