Audi A3

Since 1997 of release

Repair and car operation



Audi A3
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Manual box of a gear change
+ Automatic transmission and models with a full drive
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Electric equipment of system of comfort
   Diagnostics of malfunctions of an onboard electric equipment - the general information
   Check of the electric motor of a screen wiper
   Check of warmed back glass
   Stoplight check
   Removal, installation and check of a sound signal
   Safety locks
   Fusible inserts - the general information
   Chain breakers (thermal relays)
   The relay
   Replacement of batteries of a key of remote control
   Replacement of the battery/lamp of a key with illumination
   Anticreeping blocking
   Illumination devices
   Replacement of lamps of external illumination
   Replacement of bulbs of internal illumination
   Removal and headlight installation
   Removal and installation of the electric motor of adjustment of range of light
   Removal and installation of the forward index of turn
   Removal and installation of a back lantern
   Adjustment of light of headlights
   Devices
   Removal and control panel installation
   Removal and installation подрулевого the switch
   Removal and installation of switches and lamps
   Removal, installation and radio receiver coding
   Input of a code of a radio receiver
   Removal and loudspeaker installation
   Removal and installation of the aerial of a roof
   Additional installation of a radio telephone on in special way prepared models
   Removal and installation of the electric motor of a forward screen wiper
   Removal and installation of the lever and the electric motor of a back screen wiper
   Removal and installation of a cleaner of back glass
   Removal and installation of the tank from the pump стеклоомывателя
   Elements темпостата
+ Electroschemes


https://www.youtube.com/channel/UCoah5uA-uF-j35-MalVTfRQ


Removal and installation of a cleaner of back glass

THE GENERAL DATA

Cleaner of back glass

1 – a cover
2 – a nut, 15 Н•м
3 – the lever
4 – consolidation
5 – a jet
6 – a sealing ring
7 – the electric motor
8 – a nut, 8 Н•м
9 – a rubber ring
10 – a remote element
11 – a brush

REMOVAL

PERFORMANCE ORDER
1. Cast away upward a cover.
2. Turn away a nut–2.
3. Cast away upward the lever and move sideways every which way. Thus the lever acts in film from a cone of an axis of the electric motor.
4. Turn away a nut and remove the lever.
5. Remove internal facing of a door of a back, thus address to subsection Removal and installation of facing of a door of a back.
6. Расстыкуйте a socket–1 also remove a hose–2 jets.
7. Turn away bolts of fastening and remove the electric motor (are specified by arrows) (a key in 10 mm).

INSTALLATION

PERFORMANCE ORDER
1. Cautiously insert the electric motor through an aperture in back glass. Thus watch correct position of consolidation, as is shown in an illustration.
2. Fix the electric motor the moment 8 Н•м.
3. Join a socket and put on a jet hose.
4. Establish internal facing of a door of a back, thus address to subsection Removal and installation of facing of a door of a back.
5. Put on the lever an axis so that distance and has made 25 mm. The distance is measured from the bottom edge of glass to the bottom edge of a brush.
6. Fix the lever the moment 15 Н•м.
7. Cast away back a cover.
On the main page