Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
- 11. Brake system
   11.1. A technical characteristics
   + 11.2. Prorolling of hydraulic brake system
   11.3. Brake pipelines and hoses
   + 11.4. Lobbies brake Pads
   11.5. Replacement back brake колодок on disk brakes
   11.6. Replacement back brake колодок on drum-type brakes
   11.7. Check, removal and installation of a forward brake disk
   11.8. Check, removal and installation of a back brake disk
   11.9. Removal, check and installation of a brake drum
   + 11.10. A support of a forward brake
   + 11.11. A support of a back disk brake
   + 11.12. The back working brake cylinder
   + 11.13. The main brake cylinder
   - 11.14. Valves of adjustment of pressure
      11.14.1. Check of valves
      11.14.2. Removal of valves
      11.14.3. Installation of valves
   11.15. Replacement of the unidirectional valve of the vacuum amplifier of brakes
   11.16. Check, removal and installation of the vacuum amplifier of brakes
   11.17. Removal and installation of a pedal of a brake
   11.18. Removal and installation of a cable of a manual brake
   11.19. Removal and installation of the lever of a manual brake
   11.20. Replacement brake колодок a manual brake on back disk brakes
   + 11.21. Antiblocking system of brakes (ABS)
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes





11.14.2. Removal of valves
PERFORMANCE ORDER
Models the Hatchback and the Sedan
1. Remove a liquid from the main brake cylinder.
2. Establish the corresponding container under the main brake cylinder that at unscrewing of valves to collect the flowed out brake liquid.
3. Mark brake tubes, then unscrew connecting nuts and disconnect brake tubes from valves of adjustment of pressure.
4. Close the ends of tubes suitable stoppers.
5. Unscrew valves of adjustment of pressure from the main brake cylinder and close apertures of the main brake cylinder suitable stoppers.
Models the Versatile person and the Van
6. For reduction of losses of a brake liquid uncover with пополнительного a tank of brake system, close a mouth of a tank polyethylene and again screw a cover. It is necessary that the cover tightly closed пополнительный a tank.
7. Lift a back part of the car and fix on supports.
8. Loosen the an arm of a spring of the valve of adjustment of pressure, move an arm back and disconnect from it a spring.
9. Clear area about connection of pipelines to valves of adjustment of pressure.
10. Mark and disconnect pipelines from the valve of adjustment of pressure.
11. Close the ends of tubes suitable stoppers.
12. Unscrew bolts and remove the valve of adjustment of pressure.

On the main page