Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
- 11. Brake system
   11.1. A technical characteristics
   + 11.2. Prorolling of hydraulic brake system
   11.3. Brake pipelines and hoses
   + 11.4. Lobbies brake Pads
   11.5. Replacement back brake колодок on disk brakes
   11.6. Replacement back brake колодок on drum-type brakes
   11.7. Check, removal and installation of a forward brake disk
   11.8. Check, removal and installation of a back brake disk
   11.9. Removal, check and installation of a brake drum
   + 11.10. A support of a forward brake
   + 11.11. A support of a back disk brake
   + 11.12. The back working brake cylinder
   + 11.13. The main brake cylinder
   - 11.14. Valves of adjustment of pressure
      11.14.1. Check of valves
      11.14.2. Removal of valves
      11.14.3. Installation of valves
   11.15. Replacement of the unidirectional valve of the vacuum amplifier of brakes
   11.16. Check, removal and installation of the vacuum amplifier of brakes
   11.17. Removal and installation of a pedal of a brake
   11.18. Removal and installation of a cable of a manual brake
   11.19. Removal and installation of the lever of a manual brake
   11.20. Replacement brake колодок a manual brake on back disk brakes
   + 11.21. Antiblocking system of brakes (ABS)
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes





11.14.3. Installation of valves
PERFORMANCE ORDER
Models the Hatchback and the Sedan
1. Check up that new the valve have the same type, as earlier established. Replacement of valves make in the complete set even if out of operation there was only one valve.
2. Screw in valves in the main brake cylinder and tighten their demanded moment.
3. Connect brake tubes and tighten connecting nuts the demanded moment.
4. Pump over brake system.
Models the Versatile person and the Van
5. Remove with old and establish on the new valve a protective casing.
6. Establish the new valve into place and fix bolts, having tightened their demanded moment.
7. Connect to the valve brake tubes and fix nuts, having tightened their demanded moment.
8. Pump over brake system.
9. Establish a spring on the valve and an arm.
10. Adjust arm position so that the spring tension was an average and fix an arm.
11. Lower the car on the earth.
12. Make a control trip and check up work of back brakes.

The prevention

Keep in mind that at increase in a tension of a spring pressure in back brakes and on the contrary increases.


On the main page