Opel Kadett E

1984-1991 of release

Repair and car operation

Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
- 6. Fuel and exhaust systems
   - 6.1. Models with the carburettor
      6.1.1. A technical characteristics
      6.1.2. Use unleaded gasoline
      6.1.3. Removal and installation of the case of the air filter
      6.1.4. System of adjustment of temperature of air arriving in the engine
      6.1.5. Check, removal and installation of the fuel pump
      6.1.6. Removal and installation of the gauge of level of fuel
      6.1.7. Removal and installation of a fuel tank
      6.1.8. Removal, installation and adjustment of a cable of an accelerator
      6.1.9. Removal and installation of a pedal of an accelerator
      6.1.10. Removal, installation and adjustment of a cable of management air заслонкой
      - 6.1.11. Carburettors
         + Adjustments on the carburettor 32 TL
         + Adjustments on the carburettor 35 PDSI
         - Adjustments on the carburettor 1В1
   Turns of idling and quality of a fuel mix
   The accelerated turns of idling
   A block cover заслонки
   A vacuum diaphragm throttle заслонки the secondary chamber
   A backlash air заслонки
   The basic adjustment throttle заслонки
   Productivity of the accelerating pump
         + Adjustments on the carburettor 2Е3
         + Adjustments on carburettor Varajei II
      6.1.12. Check of the electromagnetic valve of a stopping delivery of fuel
      6.1.13. Removal and carburettor installation
      + 6.1.14. Carburettor repair
      6.1.15. Removal and installation of an inlet collector
      6.1.16. Removal and installation of a final collector
      6.1.17. Removal and installation of a heater of an inlet collector
      6.1.18. Removal and exhaust system installation
   + 6.2. Models with system of injection of fuel
   + 6.3. Models with engines 16D and 16DA
   + 6.4. Models with engines 17D and 17DR
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes The accelerated turns of idling

Arrangement of elements of adjustment of the accelerated idling

And – combination of the lever with an emphasis,

In – a label,

With – the screw of fastening of a plate of a cam

1. Warm up the engine to normal working temperature and connect to it a tachometre. Switch off the engine.
2. Completely take the handle of management air заслонкой. Check up that the lever заслонки on the carburettor was combined with an emphasis, and the label on a cam was combined with a label on the adjusting screw.
3. If necessary ослабьте the screw on a cam plate, combine labels and tighten the screw.
4. Start the engine, without opening throttle заслонку. At completely open air заслонке the accelerated turns of idling should correspond to the data resulted in subsection 6.1.1. For adjustment remove заглушку and, rotating the adjusting screw, establish the demanded accelerated turns of idling.

On the main page