Subaru Legacy/Outback

1. Establish a steering wheel in neutral (central) position and make sure of straightforwardness of installation of naves of forward wheels.

2. Ask the assistant to rotate slightly a steering wheel to the right-to the left and try to estimate the moments of the beginning of turn of wheels visually. Measure size of a free wheeling of a steering wheel (on rim lateral aspect), compare results of measurements to requirements of Specifications.

3. Make sure that axial люфт a steering wheel on a shaft of a column does not exceed 0.5 mm.
4. Make trial runs of the car with check of following parametres:

a) Rotary effort: resistance of the helmsman of wheels to rotation should be uniform and identical on all length of a course;
b) steering wheel Withdrawals (course stability of a vehicle): the steering wheel should not leave spontaneously in any the parties at movement on an equal horizontal covering;
c) steering wheel Palpation: palpation of a steering wheel during movement should be absent completely;
d) steering wheel Return: at release the helmsman on termination of turn it should come back in neutral position.

2. In case of need tighten fixing bolts шарнирной assemblages with demanded effort (24 Nanometers).

1. Tyre out the car on an equal horizontal platform, whenever possible with a firm covering and serially turn a steering wheel on 90 ° in each of directions.

2. At the turned steering wheel visually estimate a condition of protective covers of the steering mechanism. Estimate correctness of landing and reliability of fastening of protective covers, grease sealing sponges of covers. In case of need eliminate deformations of covers the convergence which have arisen during adjustment of wheels, - develop in the corresponding party external edge of the braided cover.

3. Check up reliability of a tightening of fixing bolts, in case of need tighten fixture with demanded effort (59 Nanometers).

4. Quickly rotating a steering wheel to the right-to the left, estimate correctness люфта gearings of elements реечной transfers of the steering mechanism. If functioning реечной transfers is accompanied by extraneous noise, make adjustment люфта gearings: a) Tighten the adjusting screw with effort of 7.4 Nanometers, then again release it, - repeat the given procedure twice; b) Tighten the adjusting screw with effort of 7.4 Nanometers and then ослабьте it, having turned back on 25 є; c) Grease at least 1/3 full perimetres of a carving surface of the adjusting screw with liquid greasing; d) Screw контрящую a nut and, keeping the adjusting screw a wrench, tighten a counternut with demanded effort, - take advantage of key ST 926230000.

2. Check up reliability of fastening of tips to rotary fists, estimate a condition dusterов and check up люфты spherical fingers. In case of need tighten корончатые nuts of fastening of tips with demanded effort, then tighten them within a corner 60 ° before combination шплинтовых apertures. Block nuts new шплинтами.
3. Check up effort of a tightening of lock nuts of tips of steering draughts. In case of need tighten nuts with demanded effort.

1. Check up pressure head and returnable hoses of the steering pump on presence of cracks, swellings and other damages. Replace defective hoses.
2. At the cold engine check up effort of a tightening of bolts and nuts of fastening of the pump.