Subaru Legacy/Outback

1. Prepare a necessary stock of greasing of a demanded grade and a lubricant pistol for stuffing of hollow components.

On some knots instead of lubricant unions can appear are established заглушки, - take care also of presence near at hand the complete set of unions, - are issued carving штуцерные nozzles of the various form providing adequate access to almost any component.

2. Having glanced under the car, find lubricant unions of components of a steering drive, a suspension bracket and трансмиссионной lines. Usually unions enter into a regular complete set of such knots, as tips of steering draughts and карданные hinges. If instead of unions are established заглушки, instead of them it is necessary to screw prepared штуцерные nozzles.
3. Поддомкратьте the car also establish it on the props got under a frame, or tyre out its lift.

If assume at given stage to make rotation of wheels, do not forget to weaken fixing nuts before wheels will be torn off from the earth.

4. For procleaning of a nozzle of a pistol from a dirt squeeze out a few greasings. Wipe a nozzle pure rags.
5. Prepare a stock of rags and start stuffing of components by greasing.
6. Wipe the lubricant union and a surface of a component surrounding it pure rags, connect to the union a nozzle of a pistol and start stuffing. Continue закачивать greasing until it will not start to exude through joints of landing surfaces of a component.

If greasing starts to exude through a pistol nozzle, it is necessary to clean and give particular attention it to clip density. In case of need replace the union.

7. Rags collect from a surface of a component surplus of greasing and pass to stuffing of the following knot.
8. Stuffing of a sliding collar of the universal hinge карданного a shaft continue until greasing will not start to exude an assemblage epiploon.
9. At stuffing карданных hinges of usual type greasing should start to exude through joints of components of assemblage.
10. Without getting out from under the car, wipe cables of a drive of a lay brake and with fingers grease their directing and executive levers.
11. At a corresponding complete set of the car put greasing on литиевой to a basis on contact surfaces of persistent arms and adjusting bolts of assemblages of rotary fists.
12. Open a cowl and fill a few greasings for the chassis in the mechanism of a latch of the lock. Ask the assistant to extend against the stop the lever отпускания the cowl lock under the panel of devices and grease all bared surfaces drive a cable.
13. With liquid impellent oil grease loops of all doors and a cowl.
14. For greasing замковых cylinders it is the most convenient to take advantage of the graphite greasing delivered in aerosol баллончиках, - ask in shops of automobile accessories.
15. With silicone greasing grease sealing tapes of doors for the purpose of their protection against premature deterioration.