Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
- 11. Brake system
   11.1. A technical characteristics
   - 11.2. Prorolling of hydraulic brake system
      11.2.1. Prorolling – the basic method (two persons)
      11.2.2. Prorolling – use of the complete set with the unidirectional valve
      11.2.3. Prorolling – use of the complete set of prorolling under pressure
      11.2.4. All methods
   11.3. Brake pipelines and hoses
   + 11.4. Lobbies brake Pads
   11.5. Replacement back brake колодок on disk brakes
   11.6. Replacement back brake колодок on drum-type brakes
   11.7. Check, removal and installation of a forward brake disk
   11.8. Check, removal and installation of a back brake disk
   11.9. Removal, check and installation of a brake drum
   + 11.10. A support of a forward brake
   + 11.11. A support of a back disk brake
   + 11.12. The back working brake cylinder
   + 11.13. The main brake cylinder
   + 11.14. Valves of adjustment of pressure
   11.15. Replacement of the unidirectional valve of the vacuum amplifier of brakes
   11.16. Check, removal and installation of the vacuum amplifier of brakes
   11.17. Removal and installation of a pedal of a brake
   11.18. Removal and installation of a cable of a manual brake
   11.19. Removal and installation of the lever of a manual brake
   11.20. Replacement brake колодок a manual brake on back disk brakes
   + 11.21. Antiblocking system of brakes (ABS)
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes





11.2.2. Prorolling – use of the complete set with the unidirectional valve
THE GENERAL DATA

The complete set consists of a tube with the unidirectional valve established on it which excludes possibility of return to brake system of a remote brake liquid with air vials. On some complete sets the transparent container in which air vials in a brake liquid are well looked through is established.

PERFORMANCE ORDER
1. Remove a dustproof cap from the union of prorolling of the wheel cylinder, clear it and dress on it a hose from the complete set.
2. Unscrew on half of turn the prorolling union.
3. Smoothly press a brake pedal against the stop and slowly release it in a starting position.
4. Repeat this operation until from the prorolling union there will be no brake liquid without air vials.
5. Tighten the prorolling union against the stop, remove from it a tube and dress a dustproof cap.

The prevention

At air removal constantly watch presence of a brake liquid in a tank, without supposing an exposure of its bottom as thus air again will get to system.


On the main page