Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
- 11. Brake system
   11.1. A technical characteristics
   - 11.2. Prorolling of hydraulic brake system
      11.2.1. Prorolling – the basic method (two persons)
      11.2.2. Prorolling – use of the complete set with the unidirectional valve
      11.2.3. Prorolling – use of the complete set of prorolling under pressure
      11.2.4. All methods
   11.3. Brake pipelines and hoses
   + 11.4. Lobbies brake Pads
   11.5. Replacement back brake колодок on disk brakes
   11.6. Replacement back brake колодок on drum-type brakes
   11.7. Check, removal and installation of a forward brake disk
   11.8. Check, removal and installation of a back brake disk
   11.9. Removal, check and installation of a brake drum
   + 11.10. A support of a forward brake
   + 11.11. A support of a back disk brake
   + 11.12. The back working brake cylinder
   + 11.13. The main brake cylinder
   + 11.14. Valves of adjustment of pressure
   11.15. Replacement of the unidirectional valve of the vacuum amplifier of brakes
   11.16. Check, removal and installation of the vacuum amplifier of brakes
   11.17. Removal and installation of a pedal of a brake
   11.18. Removal and installation of a cable of a manual brake
   11.19. Removal and installation of the lever of a manual brake
   11.20. Replacement brake колодок a manual brake on back disk brakes
   + 11.21. Antiblocking system of brakes (ABS)
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes





11.2.3. Prorolling – use of the complete set of prorolling under pressure
THE GENERAL DATA

Use of the complete set of prorolling under pressure demands giving to it of the compressed air for what it is possible to use the beefy tyre of a spare wheel. Reduce pressure in the tyre to the size specified in the maintenance instruction of the complete set.


The prevention

Opel recommends to use the compressed air submitted under the pressure of no more than 2 bar.


At prorolling by this method the considerable quantity of a liquid for hydrosystem is necessary to prevent air hit in the main brake cylinder in the course of prorolling that often occurs, if liquid level in a tank is not supported.

Prorolling by pressure is especially effective, when the system is difficult for prorolling or when full prorolling of system is spent during usual replacement of a brake liquid.

PERFORMANCE ORDER
1. Connect the filled brake liquid the container to пополнительному to a tank of the main brake cylinder.
2. Prorolling process begins after unscrewing of the union of prorolling on half of turn.
3. After when will stop вытекание a brake liquid with vials of air and the pure brake liquid will follow only, screw up the prorolling union against the stop.

On the main page