Subaru Legacy/Outback

1999-2003 of release

Repair and car operation



Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
- Manual box and differential
   Specifications
   The mechanism of blocking of inclusion of a reverse gear - the device and a functioning principle
   Interaxal differential - the device and a functioning principle
   Removal and installation трансмиссионной assemblages
   Check of a condition and replacement of elements of support of a suspension bracket трансмиссионной assemblages
   Check of a condition and epiploon replacement
   Removal, installation and check of a condition of gauges-switches
   Removal, installation and check of a condition of the gauge of speed (VSS)
   Preparation for performance of major repairs РКПП
   Removal, service and installation of a distributing box and transmission lengthening
   Removal, service and installation of a leading gear wheel of the distributing mechanism
   Removal, service and installation of a conducted gear wheel of the distributing mechanism
   Removal, service and installation of interaxal differential
   Removal, service, installation and adjustment of assemblage of the mechanism of blocking of inclusion of a reverse gear
   Removal, installation and condition check картера трансмиссионной assemblages
   Removal, service, installation and adjustment of primary shaft РКПП
   Removal, service and installation of entrance shaft РКПП (models with an additional two-level reducer)
   Removal, service and installation of assemblage of a shaft of a leading gear wheel of the main transfer of a drive of forward wheels
   Removal, service, installation and adjustment of forward differential
   Removal, installation and check of a condition of a gear wheel of a drive of a speedometer
   Removal, installation and adjustment of an intermediate gear wheel of a reverse gear
   Removal, installation, check and adjustment of assemblage of gear wheels of a two-level reducer
   Removal, check of a condition and installation of plugs and gear change rods
   Removal, service and installation of the lever of gear change РКПП
   Removal, service and installation of the lever of switching of modes «Hi/Lo» an additional two-level reducer
   Removal, service and installation тросовой draughts of a drive of switching of modes of a two-level reducer
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Check of a condition and epiploon replacement

 PERFORMANCE ORDER

1. Check up an epiploon on presence of signs of development of leaks. In case of need make replacement.
2. Carefully wipe outside картер transmissions.
3. Completely merge трансмиссионное oil, then screw back and tighten with demanded effort (44 Nanometers) a drain stopper with demanded effort, - do not forget to establish into place a sealing washer.
4. Remove back section of system of release of the fulfilled gases with the muffler (see the Head of the Power supply system and release).
5. Uncover a thermofilter (see Has undressed Removal and installation трансмиссионной assemblages).
6. Remove карданный a shaft (Coupling see the Head).

7. By means of special adaptation ST 398527700 remove an epiploon.

8. Installation of a new epiploon is made by means of special оправки ST 498057300сальник.

 In quality оправки the replaceable face head of the corresponding size, or a piece of a pipe of suitable diameter will approach. Remember that оправка should rest only against rigid face edge of an epiploon!

9. The further installation is made in an order, the return to an order of dismantle of components.
10. Fill in in transmission fresh oil and adjust its level (Routine maintenance see the Head).


On the main page