Subaru Legacy/Outback

1. Remove a brake disk (see Has undressed Removal, check of a condition and installation of back brake disks).
2. Remove returnable springs of boots of a lay brake.

3. By means of a screw-driver with a flat sting remove directing spring and анкерный a finger of a forward boot of a lay brake.

4. Remove разжимную a lath with the spring.
5. Remove directing spring and анкерный a finger of a back boot of a lay brake.
6. Remove brake boots.

7. Disconnect from the executive lever of a lay brake приводной a cable.

8. Having hooked a screw-driver, remove a lock ring and separate the executive lever from a boot, - try not to lose a spring washer.
9. Check up a condition of a contact surface of a drum of a brake disk. In case of revealing of deep furrows, задиров and other damages replace a disk.
10. Measure internal diameter of a drum. Compare result of measurement to standard requirements (Rating value: 170 mm; limiting admissible value: 171 mm), in case of need replace a disk.
11. Measure a residual thickness of frictional overlays of brake boots. Compare results of measurements to standard requirements (Rating value: 3.2 mm; limiting admissible value: 1.5 mm), in case of need replace boots in the complete set for both brake mechanisms.

1. Remove rubber заглушку a service aperture from the back party of a brake board, pass in an aperture a suitable screw-driver and, rotating it the adjusting screw, achieve pressing of boots to a contact surface of a drum, then release the adjusting screw on 3-4 teeth back.
2. Having finished adjustment, establish into place заглушку.
3. Check up correctness of adjustment of the lever of raising of a lay brake, in case of need make corresponding updating (see Has undressed Removal, installation, check of a condition and adjustment of the lever of a drive of a lay brake).